Network Management

Good Day Shantha, I really appreciate the support thus far. Please how do I create reports with cisco prime infrastructure?Kindly state out the steps from Report Launch Pad. Anticipating your response. Regards, Tioluwani Irabor

Hi, Please let me know where I can get more information or whom to contact for Cisco Network taps for capturing the data. I only need info about either 10G/40G/100G Taps -Suresh

  I kindly need suggestions for a challenge I am faced with on Cisco prime infrastructure. a description of the problem(s)I am facing with the Cisco Prime device: I can't connect to it via the web management interfaceIt takes several attempts to boot...

We are no longer able to make changes, reset ports or change labels on ports using the Cisco Device Manager through any browser (IE, Chrome and Firefox).  We can view the front panel and hover over status lights but that is about it.  None of the lin...

Greetings all,I've been working on adding our floor plans into Prime Infrastructure (currently on v2.1) and we've got several buildings that have the same floor plan on several floors.  I've uploaded our image and drawn the wall obstacles for one of ...

I recently installed Cisco Prime Infrastructure 2.2 and I have 2 questions regarding configuration:1. What configurations should run for vulnerability when some event occurs on a switch an alarm is lifted in the Cisco Prime Infrastructure 2.2?2. Is t...

Hi Experts,we are using prime 2.1 in our network.And we have around 2100 devices(routers,switches,ASA,WLC's) in the prime.We are facing server slowness while accessing the Prime Device.Regards,TD.  

Hello, Is it possible to run it on Win2012R2?I have tried to install it on ESXi 5.5 but to deploy it, requres 12GB of RAM and 4Cores, my old desktop pc does not have that much resources... Or is there any way to lower the requirements? I have tried t...

Hi Jaime,This is  the CNA audit for Cisco 7600 memory utilization which has already been reviewed yesterday. Please approve the same. Regards,Mirsad Alam

Need help creating a script/applet that can bounce voice port 0/3/0 if the active call duration exceeds 60 seconds. My goal is to drop the call when users accidentally place our overhead paging system on hold or they don't hang up the phone properly....

Hello,I have been tasked with implementing a QoS policy not designed by me, and i do not have the freedom to just change it, but i would like to understand what/why my issue is going on, so that i am better informed when i try and relate what i am se...

I hit this message continuously while connection with initiator is performed and heavy io is flowing over it,  browsing on lxr I found it to be enic driver log populated when tx queue is busy,,does any1 know what are the possible cases for it to happ...

I am trying to find out if there is a way to get an SNMP trap on a switch or router to send the port description.For example my critical switches send linkup and linkdown trap alerts, these alerts will tell me if interface 1/1 or 0/2 basically x/x in...