Network Management

Hi,Does anyone have suggestions on which discovery settings are best for prime to schedule an auto discvery of the network weekly or daily?  Using the seeds IP's, it seems it might not capture all devicea accross the WAN.  I wanted to know if there i...

Hi I have NAM-2 with software version 4.2 installed in my network and i am making very good use of these module for troublshooting,I can run multiple captures files at local disk simultaneously and i can decode real time any capture file which is run...

I have a 2811 that has a bad CF slot. I don't have a USB stick small enough (4GB is the smallest, unless it'll use it partitioned as a 2GB) to copy IOS to the 2811. Right now I'm trying to copy the IOS image via xmodem into DRAM and booting that way....

Besides a RW community string on Wired switches and routers in Prime Infrastructure, are there any other special configurations required (on the Wired switch or router side) in order for the templates to be deployed.Reason I'm asking is in my lab whe...

Topology:Client <---> L2 <---> L3 <---> R1 <--- GRE ---> R2 <---> L3 <---> L2 <---> ClientThe L3 is used as gateway on each VLAN, and is therefor doing intervlan routing.VLAN topology on left side:VLAN 10 - Client - 10.10.1.xVLAN 20 - Server - 10.20....

Hi,I have set up the following in a lab:Prime Infrastructure 2.0 (2.0.0.0.294)Cisco Secure ACS 5.4.0.46.0aWindows 2003 Domain Controller för AD AuthenticationGoal: Admin access to network devices requires Authentication via TACACS+ to ACS (-> Active ...

Hi all,I have a really specific problem with exporting maps from WCS to Cisco PI 1.3. Here is the procedure I'm using to export:1. Login to WCS2. Monitor > Maps > Export Maps...3. Include map information is selected, same as Select all maps.4. Export...

                   Hi All,We have recently upgrade LMS 4.0.1 on Windows to LMS version 4.2.3.After this upgrade, there is one error that has started to occur on Inventory Dashboard in User Tracking Summary --> Unable to connect to Data base, Probable...

Hello,I need an EEM applet to notify when a particular interface goes down (Cat 4k running 3.4.1). I notice, event track command is not available under event manager. track 1 interface GigabitEthernet0/0/2 line-protocolevent manager applet EIGRP-li...

OK, the end result is good and all the attached radios are shown in the Sho-Run and the interface bandwidths are being changed to reflect the true line rates of the radios:event manager environment 2400_TX_Rate 243 Mbevent manager environment 2400_RX...

OK, I have a customer whom we are migrating from WCS to Prime Infrastructure 1.3. As I understand it, I need NCS in the middle to migrate from WCS >> NCS >> PI1.3. I have Prime NCS running, I followed instructions:http://www.cisco.com/en/US/partner/d...