Network Management

Hello LMS community, I am a bit confused about how LMS 4.2 monitors interfaces that is shutdown and hope that you can share you experince with this problem.I have a router with a vlan interface configured with an IP but shutdown.Even though LMS detec...

Hi,I just want to ask what are the dependencies for having an updated Configuration Management. Do I have to click "Sync Archive" everytime? What I'm trying to do is have the Cisco Prime be upto pace with the current configuration of the devices. For...

Hopefully im in the right section and that you can help!I download ccp to configure my router, however whenever i run it (as administrator) it only fills the top 1/3rd of my screen and cuts off a huge portion of the display (in fact you are initially...

We have a weird setup at a site which is causing us problems because it doesn't alert.  Without getting into all the details, I'll briefly give you the scenario:Scenario:The circuit connects to a carrier switch on-site, that connects to a port on our...

                   We are running Prime Infrastructure 1.3 primarily for wireless management at this point.  We have enough licenses to add all our switches, routers, and firewalls, but we're hesitant to do so until 2.0 comes out.  While there are so...

Hi,In LMS4.2.0 Device Selector is overall working except of the whole reporting with always 0 devices selected. Do you have any ideas what to can do?thx for hints, Steffen

Hello Community,Can someone please take a look at the script below and tell me why on earth the simple script won't work when I try to run it manually,event manager applet netflow_toptalkevent noneaction 1.0 cli command "enable"action 2.0 cli command...

Hello - I am trying to find some detailed information on IP SLA probes. We are implementing udp jitter probes in our network, but I am curious about what constitutes a test failure. Considering the default test parameters (10 packets, 10 bytes, space...

Dear Friends,            I am in process of configuring hsrp using dynamips       when i am putting the comand    SW1(config)#standby 1 ip 10.1.1.10                                           ^                                   % Invalid input detecte...