I am installing Personal Assistant 1.4.5 on a MCS7835-H1 with OS 2.7. After I install Enhanced TTS, the server crashes on boot at "Preparing Network Connections". Anyone seens this? Also, can you use the same OS upgrades for PA as you do for CCM?
Hello all,is anybody know how the source address of H323 gateway is determined by default? This question became sharp in our production network.The scenario follows:The gateway AS5300 should be accessible from two paths (public internet and VPN). To ...
Hi !Does Cisco VG248 support multicast ? Could a phone attached to VG248 join to multicast MOH audiostream from CCM or it has to use only unicast MOH.Thank you,Sergey
Hi,I am running ccm 4.1.3 and also siemens hi4000 epbx. i have connected these two with an E1 which is terminated in 3745 router in cisco side and in the trunk in siemens side. now the call flows properly when siemens extensions call to cisco extensi...
Hi there,what happens at CCM when a user dials (e.g with TSP from Outlook Address Book) +3312345678?supports the CCM special characters like the +?thanks Manfred
Can a configuration be done to have an IP phone connect through one gateway to another? Other than the correct IOS is there a need for voice cards in the invening gateway?
Using CCM 3.3, MGCP Gateway, how can I block an incoming call based on the caller id. For example any call coming into our system with caller id 512-111-2222 should not be allowed.
What would be best way to prepend a digit to the clid of an incoming call. We have one scenario with CCM 4.1(3) with MGCP and another with H323 gateway.Regards,Vasu
My IP Phones are stucked to register to the old CCM 3.3(3), even I have erased configuration of the IP phones and also set the TFTP to the new 4.1(2) CCM, the IP phones are still tring to register to the old 3.3(3) CCM first.I have deleted the IP pho...
We have issue where we are losing inbound calls due to calls hearing a ring, then a busy. 2811 MGCP Gateway going to CCM 4.02(a) SR1aFXO ports Attendant DNs configured for CTI Route Point DN2811 is on 12.4(1) IOS and CUE is on 2.1.1CTI RP is a AutoAt...
please help with the followings: have 2 CME routers linking each other via VPN. I need to config for the CoS on the LAN switches on each side then map them to DSCP on CME routers and finally apply these DSCP on WAN interfaces. Please help with the co...
