Other Collaboration Subjects

Hello, I'm trying to get my head around putting in VoIP across a Frame Relay link. and im new to putting in QoS across frame.We have the main office with call manager and a satellite office with 25 phones.the link has a 2meg port speed with a 1meg CI...

I am running CCM v4.0(2a) and want to configure MLA.When enable this through user>access rights>configure MLA params, I cannot login with my username and password.I have configured my username name to be in the userusergroup, but I cannot still get a...

After I changed the security mode from non secure to authenticated in callmanager 4.1(2)SR1. when the 7960/40 phone reset. The phone set use the device pool with SubPub.Normally, the phone should register to subscriber; publisher as backup server.No...

I can sit on an IP phone and press the messages key or dial 999 to access UE no problem, but when I dial in from the PSTN into the PRI the IP phone rings no problem. My problem is when the "call-forward noan timeout" occurs to 999 the call gets dropp...

Using Linksys RV016 router for remote access into corporate LAN. Need to know which ports to open on Linksys for IP Communicator so that I can establish 2 way audio from behind the Linksys into my LAN

I need to pepend a 9 digit for outbound pstn calls to calls in the missed calls directory. this only affects calls with 7 digits and up. Any sugestions. Prepends the 9 on incoming from the voice gateway are out due to customer requirements. Thanks...

Hello, Could someone tell me when would a call me considered to be in broadcast queue. How could someone send a call to broadcast queue.Thanks

The 4.1.2 upgrade assistant fails on a 3.3.3 SR4A cluster with the following error:No system access section exists for the security policies.The not so helpful corrective action given:The program cannot access the security settings on your system.Any...

How do you remove tone on hold on Call Manager 4.1(2). We want silence. Thanks!

Hi All,Working on my first CCM, so I'm a newbie, I have hit a few issues and might be posting more questions ;-)Have CCM 4.1.3 on a HQ site, HQ router is a 2811 and a remote site connects to 1750 via 1MB serial.Both sites have abt 44 users, customer ...

Here is my design issue about the route plan:Customer has two carrier( say A and B) for one of the offices and each provides 1 T1 for this office as a redundant mechnism. The problem is the conflict of NXX(office number)dialing plan between these two...

Hi All,I know this is a bit off but would appreciate any suggestions or ideas.For a normal analog line, is there any way / products out there which allows you to monitor the line for statistics for billing?Again, I apologize for this but I really wan...

So there's this IP phone, see...actually a couple of them...they don't like my servlet sending http requests to them.Here's one of my logs for today to one of them.Start Paging: May 13, 2005 1:32:36 PMPP401-Opened: 172.29.1.103Start Push: 172.29.1.10...

We are experiencing an issue with DTMF over an ATA 186. The ATA is used as an interface to a trascription(voice recording) analog device. The transcription device requires use of DTMF tones to log users in and control the stopping and starting of r...