Other Collaboration Subjects

Hi, My customer has a cluster of Call Manager in 3.3.4. I have install UNITY 4.0.4 for Lotus Notes. Few IP Phones have MWI always lit, but user hasn't not new mail or voicemail. I have select all messages in mailbox and mark as read. But the problem ...

We have run into an issue where we have turned down our keep alives to go out every 10 secs. So when three are missed in a row then the phone will go into SRST mode. The default is 30 secs. The problem we are running into is that in our Disaster R...

Hi,Does the IP phone generate 802.1P or 802.1Q frames by default? (Is it for both data and voice traffic?)RegardsM

Hi,What is the idea behind specifying the voice VLAN under the interface? (Is it needed for both 802.1P and 802.1Q?)RegardsM

Good day, Does anyone have any experience with the Cisco DPA 7610? We have been integrated for about 1 month now (CCM 3.3.4, DPA 7610 1.3.1ESS, Meridian Option 61C and an Octel 250). We are receiving about 50 hang-ups a day from port numbers associ...

Hi, I install an AutoAttendant with CTI Route Point Number 4000, i have an other CTI route point for IPMA with the number 40XX, and i have a pilot point with the same number than the AutoAttendant Number 4000. What is the interaction between this ser...

CCM When upgrading from 4.0(1)sr2a to 4.0(2) we had the following error on the Pub:Aupair.exeThe instruction at "0x00000000" referenced memory at "0x00000000". The memory could not be read.Click OK to reminate the program.We clicked OK & the install...

Just wondering what everyone considers is the best way to configure a gateway for outbound PSTN calls using SRST?Seems like the options are:1) Configure dial-peers for the necessary patternsor 2) Use the "access-code" commandsSeems like the first lea...

How can I make all the 6 lines on the IP phone model 7960 all busy out? Is there some service that can make the DN appear busy? Thanks.

Hi,We have CCM 4.0(2a) installed on MCS 7835 server with dual NIC cards.Is NIC card teaming recommended on these servers.RegdsKMS

Hi All,I'm having an issue with MOH and dropping a .wav file into the DROPMUHAUDIOSOURCEFILESHERE directory.Nothing happens. I have 1 Publisher and 1 Subscriber CM Server.Also, when I check the DEBUG txt file in the TRACE/CMS directory, it sais the ...

Hi all,I am facing a typical problem with TABSync application to synchronize Outlook Express Address book with LDAP Address book.Problem: I am able to synchronize with CCM 4.0 but not with either CCM 3.2 or CCM 4.1 with the error message "User has no...

Folks, Have a 4.0(2a) CCM cluster. With 1 Publisher and 2 Subscriber. Lately, I have been getting this error.Error: MtpNoMoreResourcesAvailable - No more MTP resources available. App ID: Cisco CallManager Cluster ID: StandAloneCluster Node I...