For no appearent reason the check box nest to forward to voice mail under the line config page is showing up unhecked on random users phones about 2 a week now. There is no appearent pattern and when i check it again it seems to stay.Thoughts?
I have assigned IP Address to call manager which is 192.168.2.200 i have registered two cisco 7940 in call manager. I can make calls with in the same network.Now i would like to make call from diffrent subnet.Basically location 1 has got call manager...
Dear Expert:I am running CME 3.2 with 7940 IP Phone and I had been try to configure 'secondary call coverage' with button overlay feature, I use 2nd button of IP Phone 7940 for two other extensions, however when incoming call to second overlay numbe...
dear sir, anyone have any idea how to change the entire did number? Let say the did number that we running now is 111XXXX , i wish to change it to 222XXXX. please advise. thanks.
Hi all,how can I load 7941 phone on CME, what parameter should I enter in config,I found somewhere:load 7960-7940 P00307020200but this file I am loading for 7912 IP phones, so what is correct?regardsSlawek
hi all,have the problems as described in Tac Case Collection "K13474527" "Calls drop and the user receives the CM Down Features Disabled error message when making calls with a Cisco IP phone".This is independent from srst or wan failures, because the...
I have configured my router with CME 3.3 and now I'm trying to configure an autoattendant, I have tried a lot of things but it doesn't work, this is my config:!version 12.4service configservice timestamps debug datetime msecservice timestamps log dat...
In Unity I have a call handler that is the main greeting for an office. If the call presses one, it transfers them to a new call handler that promts them to enterthe extension of the person they are trying to reach. If the extension is valid, it tr...
2811 on 12.4(3c), MGCP w/ CCM 4.0(2a)SR2b. My PRI dropped for 2 minutes yesterday and when it came back up, incoming calls resulted in reorder. Q931 debugs showed the call presenting to the router, but the router was dropping the call immediately, ...
I just brought up a site that should use only G729 between other sites and internally. Reviewing CDR data I see a occasional call using G711. Most of these calls go to Unity but I can see no reason why this would be. There are also calls to Unity th...
Working on a Nortel integration with Unity using a intel Dialogic D/120JCT. As soon as I plugin the analog line they go off hook. If I connect a phone I can make a call. I tried changing SW1 settings.. no luck Do I have a bad card ? Its the only c...
