Other Collaboration Subjects

Hi , how i can make a configuration of a hotline in ATA 186 SCCP. I have a CCM, but the hotline works just in one direction not in both directions.Thanks,Gonçalves

Hi,Would like to list in this topic all solutions you are using to connect analog terminals on IP Telephony solution !!!Here is the beginning of the list for me:- ATA : 2 analog port. one G729 et one G711 => Cisco.com- FXS card on IOS router => Cisco...

CCM4.13 with 2811 T1 PRI MGCP.It might be a stuipd question, but I just so curious.Usually, it will generate default dial-peer like following:dial-peer voice 9991023 pots application mgcpapp port 1/0:23!For some reason, my configuration doesnt have ...

after upgrading to 4.1.3 **#** is not rebooting the phones it goes through the dial plan and the digits failon 7912 we get a promt to click "yes" to reboot

Is it possible to forward all the lines of a phone(the phone has more than one extension) to a different numbers from the pone itself(not from the web interface)?

I know I should be going off Erlongs, and all that fun stuff.. but are their any industry standards for PRI sizing? For instance..4 DIDs to 1 PRI Channel?Thanks

Fresh newly installed web server - windows 2000 SP4. Installed Cisco IP Services SDK 3.3.3. Trying to get intercom.asp script working.Environment - CM 4.0 and lastest SR release.Testing with 2 7940 phones. Phones subscribed to http://servername/Cisco...

hi,I should stop /drop/ certain malicious incoming calls from PSTN network based on calling number. There is a PRI used on the router to terminate 5 ISDN30 channels. Does anyone has an idea how to do that? TIA,Balazs

Hi all, I'm trying to configure SRST 3.4 with Call Manager 5.0.2I have installed IOS 12.4.6T (advanced enterprise) on my 2811 Router.(SRST 3.4 supported in the Feature Navigator for this IOS)But If I try to configure the Router according to this Docu...

Folks, How can i program my ccme efficiently so that i can do 7 digit, 10 digit and 11 digit calls efficiently. this is what i have write now, but it does not seem to work for local calls.dial-peer voice 1005 pots destination-pattern 8[2-9].......

I have a question on how to extract the Spoken Name (recorded name) of a user from CUE directory . I have an AA script in which I prompt the user for Dial by Name. I am using the "Name to User" step to extract the name keyed by the enduser, check the...

Just to know how to set up connection so I can access extension from one CCM to another, using intercluster trunk non-gk. Do i have to setup intercluster in both CCM? and what more?.Thanks

We don't remember the private password phrase, and to start the instalation the wizard need this.Were We found?Thank Juan