Other Network Architecture Subjects

Dear friends,I configured Username and Password on Cisco Switch 4507R on all the lines,By mistake I removed username and password from the switch but I didn’t disable from the line’s when I’m trying to login on switch it’s asking username and passwor...

Hi,What exactly "*-valid" in bgp table means? What is checked before a route is signed with this code? Next-hop reachability or anything else? thanks

Hello all,I have a 6509 in the core/distribution of our network. There is also a directly connected 6509 as the backup and is not currently being utilized. We have 4507R, 3750G, and 4503 switches in the closets connected to the two 6509 switches.We...

Hi All,Can we configure GRE tunnel on following models...Regards

Good day everyone.I'm going to have a 1605R router and I'd like to use it combined with an ADSL ethernet router.Now my problem is... I kept searching and searching all over the featureset navigator but I can't find any PPPoE support.This would make m...

Hello all.I have the following ACL defined and applied:interface FastEthernet0/0.3 encapsulation dot1Q 3 ip address 10.250.16.2 255.255.255.128 no ip redirects ip accounting output-packets standby 3 ip 10.250.16.1 standby 3 priority 110 standby 3 pre...

We have a pair of Sup720s which have static ARP entries configured which map a unicast IP address onto a multicast MAC address so that packets destined for this destination are sent to multiple hosts for redundancy (e.g. clustered services).For this ...

Let's say I have two networks connected via | |192.168.0.0/24|---------|192.168.1.0/24 | |Both are able to reach each other via simple static routes. What configuration should I set in each router config in ...

first of all, i am a cisco student, and i really need help on this one.in class, we were doing password recovery with the 2500 routers. ( http://www.cisco.com/en/US/products/hw/routers/ps233/products_password_recovery09186a0080094795.shtml )So i get ...

HiI am currntly setting up a CAT6509 using native IOS which has a FWSM, IDS and NAM. The FWSM is configured with various VLANs assigned (firewallingbetween VLANs being performed). We have one SVI configured on the MSFC for communication with the "out...

Greetings,I just acquired, and am in the process of configuring a PIX515E (6.3). I noticed that allows:fixup protocol sip 5060fixup protocol sip udp 5060We need to also allow rtp udp 8000, but I don't see RTP supported. Please advise. Thanks.Rob

If we use an HTTP inspection rule we get very poor download performance.We have demonstrated this using the default setup created by CRWS. When set up this way the router performs just fine. If we add the following:-Ip inspect name myfw http Then the...

Hi.Just recently, I deleted an interface dialer profile and added a new one, using the same ISDN number as the deleted dialer.I also cleared the static routes from the old profile and entered the new route.Of, course, I did the same with the username...

I have a switched network with Catalyst 3550 switch and I'm deployment VLAN and InterVLAN routing. The problem is how I be able traffic the two VLAN at same port, Voice VLAN and data, but the phones are not Cisco. I have not been to qualify the traff...

Currently, I have 2 Cisco Giga Switch (2924). Plan to buy another new Giga Switch (3750). What is the best method to join the 3 switches together.