Other Network Architecture Subjects

What is currently considered to be the best way to connect 2 Cat 6500’s together?These are on different floors with both fibre and copper linking them, I have read recently that a routed environment is the best option.In summary the Cats are 6500’s w...

Does anyone have any info on how to configure aCisco 678 router to use both statis and dynamicIP addressesTerry

We're currently running LMS 2.1 and would like to updade it to LMS 2.2 since Cisco seems to be paying more attention to the components in the LMS 2.2 than LMS 2.1. Does anybody happened to know if we could do the update from LMS 2.1 to LMS 2.2 by usi...

I know that to access an instance of BRIDGE-MIB, I have to use community string indexing. But what if I want to access them via SNMP V3 user base authentication?Thanks.

Anyone have tried to run NBAR on MSFC, I'm interested on get info using NBAR MIB.I've seen that NBAR MIB is available since IOS 12.2.15 and just SUP720/MSFC3 is running IOS over 12.2.15.

In one of my wan router I am seeing large number of packet drops in "large Bufers (size-5024 bytes). Almost all interfaces on this router uses a MTU of 1500. If none of the interface are going to receive a packet of more than 1500 bytes then why am i...

I am building a small network useing WS-C3550-24-FX and WS-C2950C switches. the switches fiber connections on both models ar MT-RJ. DO I need a MT-RJ to MT-RJ crossover cable to connect 2950 FX ports to 3550 FX ports ?

We have a remote site connected with four T1's in a multilink bundle. All four circuits are a bundle member and are showing no errors.interface Multilink1 ip address 170.x.x.x.255.255.252 ppp multilink ppp multilink group 1...interface Serial0/0 desc...

Very basic questions..1. Output of any show interface commands shows reliability, txload, rxload.'reliability 255/255, txload 22/255, rxload 39/255'It show the link utilization, 255 means 100%, means 22/255*100=8.6%But I want to know, which value 255...

hallo,in my company we have many isdn leased lines.Since the last software update we have problems with this lines. (BRI/BRI Connections)the local carrier have no idea why the lines fails.At the troubleshooting we find out that the isdn switch has an...

Hi, I was wondering if it is possible to use rmon to track routes using their snmp oid value: ie: "ip.ipRouteTable.ipRouteEntry.ipRouteInfo.192.168.1.1" Therefore producing a trap or a syslog when the route vanishes from the routing table. If anybody...

Hi Guys!Does anyone know, how the CSM find out that a server is out of server withou any type of Probe configured, that is, what is the default method used by the CSM to monitor the servers.Thanks in advance.

What is use of DDR (dialer in-band etc.) under synchronous serial interfaces? I read about this in the book "CCIE Fundamentals and Case Studies".Regards.

Hello,I have a issue with two ISP links, which I "should" load balance with one 2610 Router.Trying to avoide the BGP, and expenses related to it, I am trying to realise three private networks, with two outgoing links to ISP's through NAT.I am trying ...