Other Network Architecture Subjects

Hi,Basically i am looking for router requirement for a new VPN setup for my client The Setup:-My client is having one central office & one branch office in india. The Central office is interconnected to branch office via a 2MB linkApart from this the...

I've been looking, but haven't had any luck finding a source that defines all the data returned from a "show interface ..." (serial, etc).Anybody know of a good article, paper, or anything else?Thanks in advance,J R

We have been asked to put in a Cisco 837 router, a PIX 5406e with 3DES and AES encrption and a Cisco 2950T switch. I have previously used cisco configmaker software installing cisco kit, is there something similar that will do this instead?thanks in ...

Dear all,Can anyone tell me how Cisco OER works and whether it is possible for me to make different traffic flow between teo routers?Regards,Raman.

Hi,My AS has got 2 routers, each has a WAN link to ISP. I'm running iBGP too. i tried to set the local preference of R1 higher so as to have the traffic going via R1, using the command "bgp default local-preference 200". However, the traffic stills r...

Hello,To increase the loading of web page, i want to enable proxy arp option into the UBR7114.Is the lactency can be affect ? What memory is request for it?Thank you.

I'm trying to implement NAT for privates: 192.168.91.4 and 192.168.91.43why is it that the command: show ip nat translations verbose | include 192.168.91.4 shows up the following?:i include only a fragment:RT_DST001#show ip nat translations verbose |...

Hi There,I'd really appreciate some help. I'm having a little trouble with a GB link between a 3550-12G and a 3524-XL using 5483 Copper GBIC's and Cat5 cable. The 12G is running IOS 12.1(19)EA1c and the 3524 is running IOS 12.0(5.3)WC(1) both of whic...

hi, my 3550 has a fastethernet interface with a lots of underrun and output buffer failures in output errors. this port is a trunk port. Did anyone have the same experence ? how to solve it.best regards.fred.

Hican you please advise on what the MAC address learning times are for the Cat6500 with Sup720 and for the Cat4500 with Sup5 I am looking for this info in docs but i cannto find itthanksPete

Hello, we are planning a Network Setup in which we have to assign VLAN on the basis of different Projects.So a Single PC will be the part of VLAN 2 during morning shift , same PC will be the Part of VLAN 3 during afternoon & the Same PC will be the p...

well, in my client side, there's bunch of cisco devices, now i have the dillema of either let the router take time from the Network Management system or take time from a certain router (means that router 3600/3700 series will keep time for others)......

Can anyone help, i've forgotten the password on a 2501 router and need to restore to factory settings... Any ideas???Matt

Does anyone know the OID for monitoring the status of the modules/cards in a Cisco 4506 chassis running IOS?I am looking for the OID that shows the status of each card so that I can monitor if a card has failed...Many Thanks...Wayne