Not looking for a Complex solution........I have a T1 with bellsouth and a DSL line for bellsouth...I have the T1 set up on Serial 0/1 with one static route.....I have the DSL connected to Ethernet 0/1 with a crossover cable going to the DSL Modem.....
An ISP shipped a router and CSU/DSU which included the following configuaration for the s0 interface.interface Serial0 description WAN bandwidth 128 ip address 1.1.1.1 255.255.255.252 ip nat outside load-interval 30Since this is supposed to be a 256K...
Hi all,My customer needs a solution for their new wan network. they need connectivity to two locations with isdn backup plus dial in support for 20 users. They also need Voip support...May be they will add one more location in future.Which Router,NM ...
Dear all,The configurator shows PWR600-AC-RPS-CAB:600W Redundant AC Power System With DC Power Cables?I am confused how many DC Power cables is included, is it included 4 DC power cables already? It seems this part number is enough for 2611XM-RPS, ri...
Hi, We create two interface Virtual Template. The interface virtual template are in status DOWN. Why this in this state? The configuration required a keepalive?Router A (C1750 - 12.1.5t9):interface Serial0 mtu 1600 bandwidth 128 no ip address enca...
Hi all,Need some help on isolating output drops on one of our E1 links. The links are terminated on Cisco 3745 routers on both sides, and the peak link utilization is around 60%. The links are tested clean. There is no pattern to the drops. The link...
Have cat 4500 with sup IV, occasionally get messages that some servers mac address is flapping to a port that has an APC UPS network management card in it. Tried to capture a trace, it seems like the card may be receiving packets and spitting them b...
This is probably a very simple question, however, I've searched and searched with no luck. I would appreciate some guidance.How can I determine the IP address of a device connected to a switch? In this case, I'm using a Catalyst 2950 (IOS 12.1) and...
I am planning a network subnet change. We have users on a public subnet that does not belong to them. We want to make it private (192.168.n.n). I am looking at a process that minimizes disruption. I do not want to add additional routers.Can the f...
hi,I have a question about ISIS protocol.After I setup hello interval for my isis. How can I read my setup?I used command 'show clns neighbor' command and found the hold time of the 2 neighbored router is different. WHY?"R1 Gi14/1.1 0003.a...
Hi I have a quick question Port 1209 is used for the ipcd3 protocal, or atleast that is whatis said by the people at iana, so now my question is, what is the ipcd3 protocal used for???????
Hi,If you do a "show interfaces" on a router or switch.Towards the bottom next to multicast stats.What does "0 pause input" mean?Any suggestionsregdsJohnny
