Other Network Architecture Subjects

I have the following routers should I up them to the latest IOS? They work, but dont know if they have security issues. And do I have enough memory to upgrade the IOS? IOS (tm) C2600 Software (C2600-IS-M), Version 12.1(3a)T1, RELEASE SOFTWARE (fc1...

a message appear:%AAL5-3-RXERR: Flow Hdr:(10)input packet has wrong encap for put_if/input_idb as Ocell Payload: 0000 60890080can someone tell me what this means

I have the following set up on a Cisco 3640 router with usernamepasswordenable password.I have gone into conf t, todo the folowingenable password, line con 0, line vty 0 4 and enable secret.But the password did not change. How do I go about changing ...

hi!I've created 3 subinterfaces in router1 and 3 vlan on switch attached to router1:10.71.9.x10.71.10.x10.71.11.xIn my another router which is router2 which also connected to a switch. Will i be able to add a host with either 3 of the subnets above?...

Hello.I have got below network design: Ethernet A ------------------ | | |------| | R0 | |------| / \ / \ / \ |------| |------| | R1 | | R2 | |------| |------| | | ...

I have a problem, I have follow the commands in this link:http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094aa6.shtml#copying_startupI'm using my notebook as snmp manager, and when I type# ./snmpet -v 1 -c private -v 1 -c...

HelloI have a trouble installing BBSM 5.3. After instaltion it works very unstable and very very slow. I folowed instructions for instalation. Any advices.ThanksMitar

Hello Frnds.Hope someone can help me. I'm trying to get a Topology View of my Cisco Devices in the LMS. When I look at the Summary of my Layer 2 devices it gives me a device type called "ciscoProducts.429" and when I look at the TOPOLOGY VIEW it sho...

When I want to display cat6509 by ciscoview, it report error as follow:------------------------------------device package for this device type is not installed or you are attempting to open a component inside a device.------------------------------...

hi, i am trying to get the ras (AS5300) to bring up two l2tp tunnels and then balance the sessions between them. these are the radius tunnel attributes being sent to the ras:"vpdn:tunnel-id=prueba ""vpdn:ip-addresses=10.10.10.1, 10.10.10.2 ""vpdn:l...

We recently installed a 768k Frame Realy connection to an office that is already serviced by a T1 connection.We want to use this FR connection to carry traffic for 2 specific hosts.I have been looking at various methods in order to do this, but have ...

We have an AS5300 used for dial in users. Everytime attempts to dial to it they get a busy signal. When I tried to dial from a regular phone to that number i also get busy signal.Thanks

Hello,Our internal routes flushed out of routing table time to time for some season. Could anyone please shed a light to this problem?We have four routers. Router1, router2 and router3 are fully meshed. Router3 and router4 are route reflectors as ...

Hello,I am planning to run NNM6.41 (Version 7 is only scheduled by mid 2005 !!) on Sun Solaris machine. My NNM (subnet 20.1.1.x) server is connected to the managed network (subnet 30.1.1.x) via two routers A and B running static NAT since the interco...

when my router reboot it loses his startconfig.