Other Network Architecture Subjects

I'm about to upgrade a 5505 switch with various modules attached. I'm looking for some general tips on doing this. In particular Cisco specifies RAM sizes which do not appear to match the actual file size. For example I'm running 6.4(3) which requ...

Hi everyone, I would like to use a Cisco router to share cable internet access through a 4portHUB w/uplink to 3 desktops & 1 laptop, Laptop has linux & windows.Also, i will want a (Cisco) router i can use in addition to Sybex Sims to practice for the...

I would like to install ciscowork 2000 with pentium 4 but i can't. Do you have some recommendation for me?Thank a lot

Hi to Everyone,I have a problem with dialing two different ISP.They have different dialin numbers, different PPP authentication method and users/passwords.Additionally one of these is free of charge, so this line/provider should be chosen first and t...

Hi allI am having a problem moving the database from an old CiscoWorks server to a new server.Both servers are running LMS 2.1 on W2K (SP3) with IDU 9 for RME and IDU 3 for Campus Manager and CMFWhen I try to restore the backup on my new server I get...

Hi group,I have a case from A dials to B by ISDN, A with idle-timeout of 30 sec and B has idle-timeout of 6o sec. They are both in 12.3 IPBase imageA can place call to B successfully by PING as interesting traffic, I keeping from router to router, bu...

I use RME 3.5.I add manually devices by name.For example, rtr-rgw1, rtr-rgw2, rtr-rgw3RME insists these are all aliases to the same device.All IP addresses are off course different on these devices and no HSRP, so they don't even share a virtual IP. ...

Does anybody know what the message below means. Tried to search but found nothing so far. This is a severity level 2 message.EARL-SP-2-SWITCH_BUS_TIMEOUT

I am using a WS-C3550-48-SMI, it it possible to assign a Vlan based on IP, rather than port?Terry

I'm using a Cat 3550 Switch for a DMZ Szenario. Beside a PIX Firewall there are severeal Servers connected to this Switch.My intention is to use private-vlan to isolate the servers from one another.now when I configure the Private-VLANS with vlan 10p...

What is the maximum number of links that can be bundled under Multilink PPP? Is a 2621 capable of handling the bandwidth of 6xT1 MLPPP?

Hi,I'm facing a problem of not able to telnet into our cisco 3660 router with 12.2(24a) version.When i say "telnet 192.168.10.3" ,message i'm getting is "connection to host lost".I'm able to login through console. I'm pasting the config which is in m...

Hi,I am seeing some packet loss within the network. what is the bes tool to find out what is causing the packet loss. or what are some good commands to see where actually it is happening. Thanks