Other Network Architecture Subjects

I try to configure static multicast routing on a router with 2 ethernet interfaces. Unfortunately it`s not possible to configure an ethernet interface as the outgoing interface for an mroute. I´ve attached a small network diagram.What have I to confi...

ok, I have been using the pix too much. I need an "in" ACL on the serial1 interface of a 1700 series router. here is what it looks like from top down:10.0.33.26|Router1s1-192.168.3.2||s1-192.168.3.1Router2|ftpserver192.168.2.18I am ftp'ing from 10.0....

Hi,Is it possible using IOS 12.3 to get a router (3725 or 2620) to automatically TFTP its running config to a local TFTP server on a scheduled basis, or do I need third party software on my LAN to retrieve it automatically.Any ideas

Hello,Sup WS-X5530-E3,SupervisorEngine III NFFC II.Show test bring me EARL III Status parameters 'U' for unknown.Question: Is this board ok or not?Thanks Ruedi-----------------sh test 1Module 1 : 0-port Supervisor IIINetwork Management Processor (NMP...

Hi everybodyI have a Cat6509 with 2 power supplies, see below please:PS1 Capacity: 1153.32 Watts (27.46 Amps @42V)PS2 Capacity: 1153.32 Watts (27.46 Amps @42V)PS Configuration : PS1 and PS2 in Redundant Configuration.Total Power Available: 1153.32 Wa...

We have the following on the remote endinterface Serialx/0/1:1no ip address no ip redirects no ip directed-broadcast no ip proxy-arp encapsulation frame-relay IETF no fair-queue frame-relay traffic-shaping frame-relay lmi-type ansi frame-relay...

This is a reposting from an old thread because the problem statement has been re-defined and I would like to start a new thread for advice.I need to re-define the problem statement as I get more info for the project: I have a network spreading on two...

We installed CWfor Windows which initialy included CView 5.4. We tride to monitor a Cat6503 with teh following version information:WS-C6506 Software, Version NmpSW: 8.1(3)Copyright (c) 1995-2003 by Cisco SystemsNMP S/W compiled on Oct 10 2003, 14:45:...

can any application in ciscoworks allow the user to view the network transfer of the core switch? we have a 6500 switch and the manager insists that he want to view the bandwidth usage and network transfer from ciscoworks. since i am newbie i really ...

HelloI seem to have run into a very difficult problem (in my opinion).Just as the title stats, but there is more to that problem.Earlier I accidently erased the ISO from flash (but lucky I had a backup). while trying to figure out a way to restore t...

Hi,I have a remote site connected to the head office with a primary leased line link and backup VSAT link.There are two VLANs on the remote site.I want to configure primary leased line link to carry VLAN 1 traffic and the VSAT link to carry other VLA...

I just got done creating about about 40 different vlans. It used to be two different subnets, but I now want to connect the two old subnets with all the new vlans together. I want to make sure I have spanning tree working correctly though. There w...

Hi, I have Cisco 3750 Switch which is connected to a Cisco Pix Firewall and to internet router. Now i have one more T1 line from different ISP and i do have one more Cisco Pix firwall. What i want is if one firewall or the router goes down then the t...