Other Network Architecture Subjects

Has anyone turned on VTP passwords after they've set up a management domain of switches? I have 25 client 6500's and two server 6500's. Do I one: only need to set the password on the server switch(s), and two: will this disrupt the management domain ...

On a 4507R Core Switch... is there anyway to see which ports may be causing problems? Our service provider says that we have a lot of collisions at the Internet Router (Cisco 1700) and says to check our network. Help...

I'm working on replacing a customer router w/ a 1605. The previous router acted as a dns-caching server, something that a 1605 does not do.In order for this router to be a drop in replacement dns queries going to the internal address need to be pass...

We have a 3620 that gets Rx FIFO Overflow errors on the ethernet interface when a particular server/disk array is connected to the network. these errors lock up the router. Are we looking at a potential virus on this particular server?specific error...

Hi,Can anyone pls advise what should I do to solve the input drop problem? I've increased the queue to the max but still there are some drops. Fyi, the traffic utilization is not that high.#sh int f0/0FastEthernet0/0 is up, line protocol is up Inp...

Hello, I need to upgrade the IOS in my CAT6509.This is what I have:WS-C6509 Software, Version NmpSW: 7.4(3)Copyright (c) 1995-2002 by Cisco SystemsNMP S/W compiled on Nov 27 2002, 16:27:21System Bootstrap Version: 5.3(1)Hardware Version: 2.0 Model: ...

Hi everyone,I have a Cisco 2610XM router with a PRI interface connected to an ISDN30. Could somebody tell me the command to see how many of the 30 lines are up at any one time?Many thanks,Daniel

Hi everyone;I've seen plenty of docs on and posts on tracking active users. I haven't had much luck with sifting through the call history on the AS5400.I'm upgrading from old Bay Networks/Nortel to Cisco AS5400s for our dialin architecture. We have ...

I just installed a WIC-1ENET in my 1760. I try to assign it an IP address of 192.168.0.249 255.255.255.0 and I get the following message:% 192.168.0.0 overlaps with FastEthernet0/0Any ideas?Thanks,RN

I have imported ~35 Aironet350 APs and they are now showing up as Not Supported Devices, they are running 11.23T, any sugestions?-Damon

Hi, I have several users who sometimes must use a dial-up RAS connection to download/upload their email. Internet access is not always available where they are traveling. We currently use Microsoft's RAS server but it can be flaky. Am I correct th...

I have a 1751 and i have connected a usrobotics modem to the aux port for isp connection i have configured all and when i open web browser on the pc, the router establish the connection.I can ping the ethernet and the dialer inteface of the router, b...

with vtp2 & pruning enabled, the number of vlans advertised will soon surpass 64; which appears to a limit on some 2924 and 2950 switches. what is the best way to redesign a campus for this situation.

Hi!Is there any program which I can use to trace layer-2 devices? Like tracert works for layer-3 devices.Thanks in Advance, Teemu