I am looking at a 6500 configuration (IOS 12.2(14)), and I am trying to determine exactly what is going on and more importantly, if the switchport configurations for the interfaces are SECURED properly. The following lines are configured on the inte...
Hi ;A very novice question We are currently running 12.0(6) and have moved to 12.2(23) on a cisco 3600 router ;can anyone point the biggest advantage we have got by moving to this version . I am trying to find this on Cisco Site but not much helpfull...
Hi there,I am trying to install a module (WS-X6516-GE-TX) into the Cat6506 (Cat OS ver. 6.1(3)), i got an orange LED on the said module and i saw "an invalid index feature on module 6". Any idea?Thanks!
Can the ports be configured to Auto negotiate the speed for just the 10/100M but not the 1000M ? In other words I'd like to control the Gig connections.
There was an error message in my catalyst 3500XL,The details of the message as shown as following:C3500XL Boot Loader (C3500-HBOOT-M) Version 12.0(5)XU, RELEASE SOFTWARE (fc1)Compiled Mon 03-Apr-00 17:47 by swati starting...Base ethernet MAC Address:...
Can any one help me to configure a 2950 switch for Port security, I am trying this commandsSwitch(config-if)#sw port-security max 1Switch(config-if)#voailation mode restricted
Hello,I want to check(via console),if an MSFC2 Card was shipped before or after Nov2001(with or without ROM installed).Found this page on cco:http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a00800a2cee.shtml#sup2msfc2Ther...
I am running cat6500 with MSFC, would like to have acess control to one particular vlan. Can someone provide some configuration example on vlan acl?Thanks
I would like to configure a Cisco router as a bootp server to load a digital terminal server with a file "mneng2.sys" from the router flash, instade from a remote bootp server over the wan.need help on configuration does it support?israel.berko@hp.co...
Hi, i have 2 physical locations with identical subnets. Because there was no link between these subnets all went fine, uptill now. Right now i want to add 1 pc to each location via one router (2611+NM-4E). Please give me a direction how to configure ...
