Other Network Architecture Subjects

Hi, everyone!I`m using QoS using CBWFQ with Frame-Relay; and if i configure:!policy-map QOS-NAMEclass VOICEbandwidth percent 50XXXX....conf.....XXXXXclass DataPlusbandwidth percent 25!class-map match-all DataPlusmatch access-group name DataPlus!ip ac...

Hi, I have a problem with the broadcast on my dual core 6509 network. 5 servers are sending huge broadcast on Vlan 100 causing the core HSRP flip quite frequently. What it does is the broadcast causing a lot of input queue drops on the core interfa...

We have recently installed 10/100/1000 line cards in Catalyst 6509 with Cat OS. I am hearing reports that the clients have problems connecting at gigabit. I have done some research into gigabit connectivity and I found that autonegotion in gigabit co...

Hi, I would like to change my destination ip...it´s possible ???For example, when I try access IP : 10.10.10.1, NAT change destination IP to 20.20.20.1.Ex:Source Address = 10.10.10.254Destination = 10.10.10.1NATSource Address = 10.10.10.254Destinatio...

Greetings,I'm looking for information on confguration tips for cisco and nortel routers using Multilink PPP. I'm attempting to aggregate (2) T1s between the two routers. Basic mulitlink PPP configurations on both cisco and nortel routers do not wor...

We are using a w2k server as our v.3.2 ACS Radius Authentication. Our extenal DB source is LDAP. On 1/2/2004 the ACS services failed and no one could dial in and access our WAN. I looked at ALL the w2k events and the ACS logs to determine the failin...

into multiple ports??

hi all,my network is 61.17.99.0/255.255.255.128.now i want this network to divide in 2 subnet.in first subnet i want 8 host and rest are in another one.pls tell me the subnet address,host address and network address for these two subnet.santosh

hi i m trying to use cisco 1751 and a vanguard 6520 router in one of my client side.1751 getting connected to Satelite link and 6520 connecting to 3 RF Links.both the cisco and vanguard are in same subnet connected in the same switch(no vlans)(factor...

Hello, We are planning to deploy a internet ready on a Hotel which will enable all hotel guests both wired and wireless conectivity. This will serve as value service for the hotel guests. Here are the few considerations we want to achieved. Plug an...

HelloI have a networking scenario where two offices will be connected with a private line. Each office will need to configure their own router and integrate into their existing network. The ISP informed me to configure the serial connection between...

Hi,my wic-2t firmware is corrupted how i download and install. when i use show diag commmand it does not show wic-1t card.

Upgraded code to 121.20.E on my CAT 6006. Today see output statistics for each ethernet interface (on 3 different blades) in the billions of packets range for the last 5 minutes.Is there a bug on the output stats, or is there a virus that manifests ...

Hello!Can anyone explain me what is PAgP silent mode used for?According to Cisco docs it is used when switch is connected to PAgP-incapable device.Then why use PAgP at all? I believe in such situation we should use the mode "on"Am I wrong?Thank you!