Other Network Architecture Subjects

Hello I have a 6506 with these modules****************** show version ******************WS-C6506 Software, Version NmpSW: 6.3(1)Copyright (c) 1995-2001 by Cisco SystemsNMP S/W compiled on Jul 30 2001, 17:50:54System Bootstrap Version: 5.3(1)Hardware ...

--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note -- ...

Please what is the difference between a 3600 series cisco 1-port channelized E1/ISDN-PRI Balanced Network Module and a 3600 series cisco 1-port channelized E1/ISDN-PRI Unbalanced Network Module?

I am wondering if this is possible.Here is my layoutDunkirk = Ser 0/1.1= 192.168.22.5 Ser 0/1.2= 192.169.22.6 Eth0 = 166.166.50.10Router 2 Ser 0/0.1 =64.25.*.* Eth0= 166.166.50.15Rome Router 1 ...

Hello...I have just completed installation of cisco vms 2.1...I seem to be having problems with the 'licensing information' screen... while trying to view this page to enter the license file information, etc... the screen simply does not display any ...

We have a 1750 router with f0/0 and s0/1. The LAN is 203.145.163.176 255.255.255.240 connected to f0/0 . .179 , . 182 and .181 PCs multicast on ip 230.0.0.0 to 230.0.0.10 . Both the f0/0 and s0/1 are configured for pim dense mode and igmp join group...

I have enabled ICMP outbound on my PIX firewall, however i am able to ping any IP address apart from the 3 DMZ interfaces on the PIX but i can ping nodes attached to these interfaces and i can ping the inside interface. Is there something i'm doing w...

I need to make a change to all the devices in rme, username and password. Is there a way to do this change without having to go through each device as there are over 150.???TIA

Is it possible to get alerts from devices connected to a cisco terminal server through their console ports, to log to the terminal server or to a different server on the same LAN ?

Hello,I have a problem with the user tracking module in ciscoworks2000. When I click on it, it connects to the ANI database and the windows become white and ...Nothing. I can't do anything with cisco works. The problem is only when I launch User Trac...

If I do a show interface Ethernet 0 on a Cisco 827H I see the state of the interface always UP UP even when a have not attached the cable. Could someone tell m if this is normal and if exists some documentation where it is related??Thanks

My central site is using Cisco2621 with 2B+1D ISDN connection and is accepting calling from 4 branches using Cisco1721 2B+1D ISDN connection.Can I know how many simultaneous call can my central site router accept?Is it 2 site?since 64Kbps to each

we have a RAS setup and the user profiles are configiured in ACS Ver 3.0 and we use AS5300 as NAS. How do we configure the situation wherein if the dial user is idle for 15 mins the user should get disconnected from the NAS.Thanks!