I need to configure subinterfaces on the following devices Cisco 800 and Catalyst 2960, but when I am trying to configure it on the router, it gives the following mistakes:router (config)# int fa0.100Invalid input detected. What's wrong?
I'd like to login ASR9001 using ssh RSA public key authentication.
So I tried to import ssh key but the command in the manual didn't work.
I've referred http://www.cisco.com/c/en/us/td/docs/routers/asr9000/software/asr9k_r4-3/security/configuration/g...
sir i would like to know the configuration commands for sfp port to become trunk,,,is normal trunk commands are enough??or any special commands required
Following router/IOS/WAN upgrade OSPF is not advertising the subnet associated with the Loopback interface. It does however advertise the actual Loopback interface address. The subnet associated with the Loopback interface is used for NAT translation...
We are currently using Cisco VPN Client for Windows 7 connecting to Cisco ASR 1000 and Cisco 3925 Routers. To start using Cisco AnyConnect Client with existing Routers:-1. Will the client still work with Router IOS ?2. What additional configuration ...
Guys, We have a core switch with two fibre lines connecting us through two different ISP's to the internet. These ISP's have provided us with a range of public ip's each. We have a few routers on some of these ip's and they are working fine and we c...
Hi,I have seen alarms within monitoring system that my primary circuit went down. During that time, no alarms on the back-up appears in monitoring system, however we did not have service in the office. We believe traffic did not switch to back up alt...
I have a few of these switches and tried to use the latest stencils but the shape is actually wrong and the port groups on the switch front are wrong. Where can I download the correct stencil? Thanks in advance
I'm attempting to use the Cisco Anyconnect Secure Mobility Client to log into my work's VPN; however, whenever I get as far as entering my credentials, I get the message "Login denied. User Message: DfltAccessPolicy (The connection met none of the re...
Hi,I have a question regarding setting up L3 point to point link between two physical locations. we have a L2 link right now and cannot be monitored.we are looking to setup a the two links we have ( copper and fiber) between two near by sites as acti...
I am working on an ACS and switched an IP address. When I went into it via the web-address it was asking for a license. Is the license tied to an IP address or tied to the ACS itself?james
I have a 4500-X connecting to an ISP device. The ISP only have 100MB how do I rate limit the interface on the 4500-X without loosing the QoS service policy on the 4500X
