Other Network Architecture Subjects

I have a Customer who currently uses CNR and I need to investigate an alternative platform. It currently runs on AIX, which is going out of support later this year.I am looking to get some information: -o Which platform is typically used in the marke...

Hi allPlease let me know what's wrong with this config. I used this one and sucessded one time but when I tried this on another 2511 , I can't dialin.------------------------!version 12.0service timestamps debug uptimeservice timestamps log uptimeno ...

I am using a 3662 router, populated with 4x NM-16AM. Some ports of the 2nd module are not answering call. If I call those ports from regular telephone, it just rings, do not pick-up the call. Other ports are working fine.My 3662 router has1) Grounded...

Hi there, May I ask when will the Cisco Works Small Network Management Solution ver 1.1 be available?many thanksDavid

We have a customer who uses Netflow Collection engine V3.6(1) to monitor Cisco 7200 and some Cat 6509 switches running IOS V12.1(13)E1.Works ok for 7200 but it misses flows for the 6509s - in fact it only gets a tiny fraction of the flows and misses ...

When i tried to discover a circuit on a router 'A' using Nethealth server(on firewall), it doesnt respond to SNMP requests. But another circuit on router 'B', which is in same Vlan as router A, was discovered by Nethealth. The snmp configs are simila...

Hi, somebody knows how I can monitoring with MRTG the lines in use in a Cisco2511? ThanksMargarita

How to add unsupported devices (cat2950, cat3550 and other) to CV 4.2?

I would like to see the amount of traffic in "real time". I use MRTG already, but this gives me a five-minute average. Is there an efficient way to do this, and if so, how?Regards,Marcel

I was wondering whether one could get a snmp based device manager for Catalyst 4006 switches. I do know about Cisco works. This is apart from using Cisco Works. I have read some where to download some files with extension *.cv file and I have not us...

I have a need to translation incoming TCPIP traffic to a serial interface configured to communicate to an X.25 conenction. The X.25 line has SVC's with 10 LU's per port. I need to be able to translate the TCPIP port combinations to the SVC's.I have...

Hello,In order to control the behaviour of Microsoft Network Load Balancing (MSNLB), I am trying to enter some static MAC addresses into our switched network. The command is very straightforward in CatOS (6.3) on the 6500 : set cam permanent <hw...

Does anyone have any configuration doc or Tech doc on VPLS(TLS)can someone give me some links

I just want to know how important to configure all the options available in service module command. It's an interface command, and allows you to do lot of things. For example,interface Serial 0/0 no shutdown no description service-module t1 clock s...

Now I encounter a issue! It's very quiz to me.I make stack of two 3550-48 EMI switchs, Master switch is working fine,slave switch will shut vlan interface when there is no end user connection.any help is very appreciated!