Can somone tell me why I am getting the following error message on the console: %Error Opening tftp://255.255.255.255/cisconet.cfg(Timed Out)I have no entry to boot from tftp server in the config file at all.Thanks
Can somone tell me why I am getting the following error message on the console: %Error Opening tftp://255.255.255.255/cisconet.cfg(Timed Out)I have no entry to boot from tftp server in the config file at all.Thanks
i have a cisco 1700 series router.how to configure a modem to the serial port , so that my remote computers can acess my router through dial up.2. what are the configurations i have to do(on router side) to set a username and password to acess my ro...
Gigabit card is installed in the server which is is connected to supervisor engine 2 uplink module through fiber cable which is 1/2 port in the 1st module of the cat 4006 . It was working fine before suddenly the traffic stopped coming from the switc...
We recently purchased the assets of a bankrupt company that included a Cisco 3600 router. We would like to know the procedure to return the router to factory default setting if the password recovery option is disabled. I wish to blow the config and...
With a 3640 router, I want to add a WIC-1T serial interface. I see that I can easily buy this card on eBay for about $50, but I am assuming it will require a WAN Interface Card Slot Module (NM-2W), but I am having trouble finding them. The ones tha...
How do you determine how much DRAM your router has? I can find flash with the sh flash command but I do not know where to find DRAM. Is it included in the sh ver command?
I have 2 1720 routers connected via hdlc. I am trying to implement isdn backup but having trouble with the configs. The serial link has been set to unnumbered . Does anyone have a similar setup who would be able to sent me the configs they are using....
Hi,does anybody know if this router can hold 400 bgp sessions ? (eBGP and iBGP )
We have 3640 router configured with subinterfaces to route between Vlan's. but we are experiencing slow network, I have done some troubleshooting I found that broadcast address is flooding the network. it utelizing huge bandwidth. is't normal to get ...
center use one ISDN line as backup for two remote spke routerwe persue a solution: when isdn is used as backup line for one spoke at multilink speed 128k, another router at the same time want to use the backup line too. So is there a way to let the f...
how can i define the native vlan on trunk mode on the 6500 ,and is it important for etherchannel in trunk mode for both switchs to have the same native vlan ?
Hello,i have th foloowing problem:we have 2 72xx Router with are running hsrp and both are connected to a catalyst 3524 Switch. To this switch there is also a checkpoint firewall-1 connected: the fireall is a cluster solution running stonebeat full c...
I want to setup a small isp 500-1000 users, all located in a small geographical area within the same area code. I can get a T-1 for about $699 per month. users will be dial-up at this stage. Issues are equipmentconfigurationsany help or feedback** bu...
Hi,I have just loaded CiscoWorks 5th Edition on a Win2000 Server and now i cannot use Netscape to run the application. Please help..
Can a trunk will be encapsulated isl on Ethernet 10M with 25XX router..thanks all !!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
08-07-2024 06:15 AM | ||
07-17-2024 11:08 AM | ||
07-17-2024 06:07 AM | ||
05-29-2024 04:52 AM | ||
02-14-2024 04:00 AM |