Other Network Architecture Subjects

Hello everybody,We need to implement a Large Scale Dialout scenario soon and I am looking for some info. Central site needs to connect to about 200 external sites (for remote management). The goal is to have all the connection data coming from a Rad...

I have cisco two 7206 and over 100 cisco 2600 routers. I have set up the 7206 and the 2610 routers as a NTP servers. The 2610 will get there NTP time from the 7206 while the 7206 will get NTP time from External. My Windows NT servers can get NTP time...

Working with my ISP on a problem where running 1 channel on my ISDN everything works fine, but when I bring up the 2 channel no data flows through the connection. They want me to have both ISDN lines connect at once, not bring up one line and then t...

Does the implementation of any VLAN creates any administrative overhead?

What's the maximum amount of RAM supported on a Cat5500 with Supervisor III (with NFFC II daughter card)? Thanks.Chris

Actually i have installed HPOpenView Network Node Manager so we are evaluating the integration with CiscoWorks2000, i need help about the solution of ciscoworks that i need: Lan Management solution?, small network management solution?, we have 30+ sw...

Hi, I am searching for info on possible conditions for Port State, which is one of the parameters displayed using dspport on the CLI.In particular, the meanings for each condition. I have thoroughly searched online resources to no avail.Thanksgreg

I have 3550-12g with one port witha routed ip 192.168.1.1. the 3550 itself ois 192.168.5.22. the por tis a 1000bt gbic. there is a 2950 attached tot his port. And 1 pc on it as a test. the 2950 gateway is 192,168,5,22 which is the 3550 switch. ...

I have two half duplex point to point circuits both going into a cisco router at either side. I was wondering if it's possible to configure one link to be used to send data and the other to receive creating a virtual full duplex circuit out of the t...

I have some applications disabled on CiscoWorks2000, such as DFMAD, DFMCP, DFMI. How can I do to enable them?

Why do i receive a response from servers when i ping 224.0.0.1 from the router since those servers do not have any streaming media configured?The router has no configuration to multicast traffic and no multicast application is known on the LAN .Tha...

We need to mix vindor equipment in one of our locations and need to utilize VRRP. If the site was Cisco only we could/would utilize HSRP but it isn't. Does Cisco support/offer VRRP on the 3640 platform?

I need my PC's that are on dynamic ip's to see the PC's with Static ip's. Two different networks. tried static routes to both networks and didn't work. All pc's getting out through same router connected to two catalyst switches. One Interace setup wi...

Cisco Peers: I have a Cisco 7500 with a nailed T-1 (emulating frame-relay). I see NO ERRORS on the interface, however I see the buffer pool statistic increment. Here's the problem... poor performance on a link that is 10% utilized. I ping and get <10...

Where do you put your bandwidth statement on your Frame Relay interfaces? I have OSPF on Frame Relay and want to put the bandwidth statement in, but am not sure how to apply it. My confusion is with these two questions:Do you put it on the main seria...