Other Network Architecture Subjects

I would like to set up an infrastructure using an LD416 with BEA Weblogic, but have been advised that they are not compatible because of BEA's use of semi-colons in the in-parameters.Is this really the case and are they totally incompatible or is it ...

Has anyone gone to Win 2k SP3 while using CiscoSecure ACS 2.6(4)? I want to upgrade the service pack because of all the security holes, but I don't see anywhere that Cisco has tested SP3. I was going to go ahead and try it to see if it breaks anyth...

Hi There,I was wondering if I can use PSTN to connect to my 2611 at work from another 2611 at home, I was thinking AUX to AUX but for some reason I not getting good results.Can I use DDR from AUX to AUX? do you have a sample config I can take a look...

I recently upgraded to a Catalyst4006 Layer 3 switch at one of our remote offices. The IOS version is 12.1(8a)EW1. VLANs have been created on the local network there replacing the flat network that previously existed. Everything is routing and wor...

Has LMS 2.0 fixed the bug in 1.x that would not allow the tracking of MAC addresses of Stations attached to the Switch port on the 7960 IP Phones?

Hello all, I don't know if this is the right forum to ask about BBSM, but maybe someone has had these problems.The first problem is the BBSM box seems to only redirect page sets located in the /ekgnkm directory. The second problem is that we have ...

Hi,I have 2 questions regarding the license issues of LMS and RWAN.I have installed the evaluation copy of the LMS 2.1. If I want to get the full license for LMS, do I need to uninstall the eval copy and then install the full license copy again? Seco...

Hi,my customer has Cisco router 3640, and he wants to connect a card with analog modems - 56k.Is there a kind of the card?Thanks, Meira.

Dear friends,Kindly anyone tell me, could I install the following in a 3662 platform.1. 1-Port 100Base-Tx, 4 port Channelized E1/ISDN PRI Balanced (NM-1FE2CE1B)2. 120 Port digital modem Module (NM-120DM)3.8-Port RECOMMENDED/Sync Serial Network Module...

I´d like discover the router´serial number by IOS command. Is there command for that??? In "show ver" and "show tech-support" and others i am not found this information but only processor board serial number.Thanks

Hi,I have been able to test a DDR solution for the following ISDN backup case using EIGRP for IP. However, it seems it's much harder to implement one for IPX. Problem is that SAP traffic is translated to EIGRP incremental updates and therefore trigge...

I have a 3640 router with logging to a syslog server. When a subinterface goes down (ie. s0/1.101), it is not logged.Any ideas.

I want to reload a router every day , is it possible and if yes how ??Because the command reload in and at have only one possibility .

Is it possible to use "dialer caller 123456" command on a dialer interface of a cisco 2522 router with async ISDN TA modems and allow access to the network from that (123456 tel number) location only?Thank you.

first time poster ...Question using ciscos ws-G5484 gbics (1000Base-SX) on 62.5 micron fiber over a distance of 600 meters connection is consistant for several months now (max spec distance is 275Meters) Anyone else using 1000Base-SX gbics at this d...