Other Network Architecture Subjects

The Cisco 7206 I'm using is running an older version boot load. Where can I download the latest bootcode from and also what is the procedure for upgrading the boot code of this router.CISCO1#show verCisco Internetwork Operating System SoftwareIOS (tm...

Trying to determine the best cisco router to use for a network that will be running about 20 gre tunnels on each router. I do not wish to over size the router and by all means not to under size my router selection.

@all... Can i apply class-map in both inbound/outbound, or is it restricted to outbound only. whereas for policy-map i understand it can be applied either in or out bound... correct me if i am wrong put in simple words, should the class-map be applie...

I have 7 subnets using a 2600 as a core frame router. Everything works great, however, their are several users that need dedicated access to the web. We currenlty use a PIX515 firewall to protect our network. In the 2600 we have NO default route sp...

I have a 7606 router with a PA-8T-V35 port adapter. This comes with the octal cable, in this case it is the DTE octal cable. I need some of the ports to be DCE and some to be DTE. According to CCO, the interface is all one way or all the other. Can I...

What is the lowest series router you can use for a T1/PRI connection?Thanks.

I have successfully (or shoud I say almost) configured BRI backup for a small office to the main office. I am using floating static routes. I define a higher weighted route for the data to fire the BRI to dial. however, it is using only one of the b ...

Can someone please tell me the difference between the following 2 commands?#ip forward-protocol udp netbios (ports 137,138,139)vs.#ip helper address 192.168.100.100TIA

Need a simple 2501/2514 FR config.I’m a recently certified CCNA and studying for the CCNP routing cert.I have spent hours trying to build a simple FR network using of two 2501’s and one 2514 (the switch). My books never give the end-to-end configura...

I've recently purchased 3 2500 series routers to setup a lab in order to study for the CCNP. My question is that I've assigned an IP and mask to E0 and the only way that I can access this interface is by enabling IP host-routing. When I ran debug all...

HI,This might be a stupid doubt..but though better i get it cleared rather than let itbug me ..The details of my Router memory as shown in the output of "she ver"cisco 3660 (R527x) processor (revision 1.0) with 57344K/8192K bytes of memoryDetails of ...

I have a problem with syslogging on Cisco5500. Configuration lines are:#syslogset logging console disableset logging server enableset logging server 2A.B.C.Dset logging level cdp 5 defaultset logging level mcast 5 defaultset logging level dvlan 5 def...

I was asked a question concerning an error that is very common when you configure a 255.255.255.252 subnet on a frame-relay subinterface? The error was something about invalid/bad ip address, the interviewer wanted me to tell him how to prevent this...

I need to connect 4 E1-links using a 3640-router. Is a NM with two WIC-slots, each containing a WIC-2T a valid configuration or would I need a separate NM-4T?

I have 50 or so remote offices connected using frame-relay with connection speeds ranging from 56k to 256k. I need to give telnet top priority followed by http & ftp without dropping http or ftp packets. More bandwidth is not an option.Would priority...