I would like to know the use of Rip command v2-broadcast in the interface mode. It is included in the IOS version of 12.2(T)C4500(config-if)#ip rip ? authentication Authentication control receive advertisement reception send a...
I do not understand the meaning of term Rate-Limit in Cisco Router configurations ! What is it and how and in which situations can I use it ? Any document related to this matter ?Regards !
Hi,Does anyone know the correct expression to monitor utilization on framerelay links.The expression I am currenly using is(ifInOctets+ifOutOctets)*8*100/ifSpeedBut for e.g when I graph the utilization for a remote site point-topoint(node) with a 2MB...
Is there anybody in the community who can give me any configuration advice for uBR7246VXR in use with PPPoE-Termination and RADIUS-authentication and -accounting. At customer site behind cable modem bridges are WinPOET-Clients operational.Exists any ...
Dear All,I can not set Multicast MAC address (Unicast IP) on Catalyst 3524XL running c3500XL-c3h2s-mz-120.5.2-XU.bin.I need to direct certain Multicast MAC Address (Unicast IP) to be forwarded to trunk port only so it will not interupt other servers ...
Hello,I have two routers interfaces on a LAN. A PIM election is made, the DR is the router with the highest IP. It is said that it's this router that send IGMP query. Another election (IGMP) is made, the query router is the one with the lowest IP add...
Is there any debug that I can use to see if data is being transferred between the x.25 segment and IP segment once the session has been established? I have a situation where the router seems to be OK with the translation but no data is reaching the e...
I am working on a project that requires a total of 128 V.90 modems for a small ISP with 900 clients. The number of modems is based on a 7:1 ratio. I am interested in finding some statisitcs to determine the bandwidth loading that can be expected wi...
Hi!Does anyone of you know an issue about using a delimiter in the username configured on a Cisco700?A customer has problems on dialing in with a 700 when placing i.e. test@test as an username.The Aggregating Router does not see the additional Inform...
Dear All,If I want to mark every packets with Precedence Bit, which command should be used between route-map and policy-map (QoS CLI) if CPU load and memory usage are taken into account?.Thank you in advance
Hello all.I'd like to ask you about some examples of configuration of RTR feature regarding to DNS.There in our network is need to have supervised DNS services, and we need the traps sent from the routers to the supervision, that the DNS is down.RTR ...
When using the device availability stats in RME 3.3 it is reporting 80% availability on certain devices almost continually (particularly with the Cat6500s). When checking the availability of these devices with continuous pings there are no packets lo...
My network currently operates approx 6 routers in London and approx 15 around europe. All european routers are connected via a single link over Frame back to the London core. The entire network is running EIGRP. We now need to use our 7206 to redi...
Can I open up a socket directly to an internet client from inside the firewall?We want to implement an asynchronous protocol via HTTP between our internet clients and a server inside the firewall. The client will send a request via HTTP (including hi...
