I am using this Kron Schedule kron policy-list steen cli show run | redirect tftp://ip/sw.cfg kron occurrence steen at 16:22 Thu recurring policy steenAnd it works fine butI need to run this occurrence at day of monthFor example I need to run it a...
Dear All, Good day. Please can you advise me, because I am studying the case for designing a layer 3 network and I want to ask where the dhcp-server should be located. My apologies for the picture.
Hi there, I have some difficulties on applying acl to block piing vlan from other other. I would like to block to ping from one vlan to other vlan. May i have you expertise to make it work . My ACL worked when host from vlan-10 ping to other h...
Do you know if there is an N9K NX-OS equivalent for ip local policy route-map with IOS(-XE)? N9K01(config)# feature pbr N9K01(config)# ip local ? ^ % Invalid command at '^' marker.Thank you,
I am getting error notification "Server Disconnected". See screenshot below; The server disconnected notification is the red icon in the bottom right hand corner. Apologies that the resolution of the image may quite poor. I have no idea what has ca...
Hello all,we have 3 switches connected in star topology. There is just one vlan configured. All the switches are experiencing spanning tree topology changes, in continuous. And all the network is experiencing some timeouts. A sample of logging event...
For school I have to make a network and I need to write down every IP address in a table. Am not so sure if my access witches belong in vlan1 (server room 1 and 2) in my IP address table.Can someone tell me if I did it right?? Thank you so much in ad...
I've created this topology as per requirement, but I'm confused as to what type it is. Is it considered a P2P?
Is there any way to force an OSPF DR election, without a topology change?
Good day, I was wondering if anyone knows how to assign specific VMware vmnic uplinks to an EPG TRUNK portgroup on an ACI integrated DV switch in VMware? I know the typical way to assign active/standby uplinks for an Application EPG is to edit the VM...
HI, I am in the process of purchasing a new ISR 4331 router But need to confirm what will the max performance with NAT pool enabled and booster license applied.We are looking for a router that is capable for processing 1 GB traffic if any knows and ...
Dears am not able to borwse or download any IOS image , i don't reach that level , simply when i click support >> download software and search it shows an error happened , i opened tac but no reply since 1 day now.i have a valid contract!
Hi All, What command should I use for our switches in order to enforce the limit of three consecutive login attempts?can't find login block-for under the switch command lists. Thanks,Yared
Hi, I want to restrict interval traffic on nexus 9k. I am little confused. Here is my scenario Vlan2 Ip address 192.168.0.1/24Vlan3 IP address 192.168.1.0/24Vlan4 ip address 192.168.3.0/24Vlan5 ip address 192.168.4.0/24Requirementservers in vlan2 sho...
What is the difference between a net bit rate and a raw bit rate?
