Other Network Architecture Subjects

Hi,I have 2 routers with a pix in the middle, the pix has an ip of 192.168.1.7 there is then a VPN connection to a remote site with the address range 192.168.254.0I have added the route as shown below for the 192.168.254.0 network and I can ping Serv...

Hi all, please what is the difference between these two modules NM-HDV2-1T1/E1 and NM-1CE1T1-PRI, can the later one be used in voice environment?please help

Hi,i'm doing some project for school and now i'm stuck...(I study Network Infrastructure Design in the Netherlands)I'm trying to control who may gain access to my network and who not using a 2621Router and two catalyst switches (2924 and 3524XL). Mac...

Is it possible to use a PIX 515 as a Inter VLAN Router? I have a 515 running PIX OS7 that is configured for 2 VLANS. The devices on each vlan can see the PIX just fine but I cannot route between the VLANS. I do have the "same-security-traffic permit ...

HiI have on one side 3560 with 4 SFP's 100 the SFP which i have is GLC-GE-100FX. and on the other side i have 2950 with 2 MTRJ connections.I want to know is it possible to connect them using SMF link.or any specific SFP which is recommended.ThanksMah...

Hi, We are trying to convert the sup720 running native ios to Catos. We are following the cisco document. the link is http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a00801350b8.shtml#720We are not able to proceed from St...

Is there a quick way to reset the RIP process on a 4500 series switch with out bringing it down?

Hi,I have Cisco Cat 3750 as access switch with ios 12.2(25r)Se1.I have connected Voice monitoring server on one of the ports.I want to configure that port as span destination port.I want to enable both transmit & receive on the port.Does 3750 support...

Hi all when I setup dmx in my pix for internet web servers, would I nat these ? or put them on public ip ? and to reach these from internal would I just route to the lan interface of my pix ?

Hi everybodyI am going to implement policy-based routing on 37540 switch.I config like this : ip routing ! ip dhcp pool vlan1 network 192.168.0.0 255.255.255.0 default-router 192.168.0.244 ! ip dhcp pool vlan2 network 20.20.x.x.255.255.0 default-rout...

Hi,Should we configure PIM protocol on all vlan interfaces or just on Vlans with multicast?Let say we have vlan 1 for management vlan 2 for servers vlan 3 for clients and vlan 4 for production. Vlan 2 and 4 have multicast applications, the vlans 1 an...

Hi,We have a problem with a pix520 connected to a 6513 switch. The interface on the pix is not responding after several (10)minutes.We changed from a 3524XL to the 6513 switch (also tried a 3550 switch) and sinds then the problems started.Other inter...

Hi,I have 2 Catalyst 3550 switches, Switch A and Switch B. Switch A is connected via trunk port to switch B. Port 1-23 of switch B are in vlan 101 whereas on port 24 trunking is enabled with switch A.Now I want ports 1-16 of switch A (which are in vl...