Here our provider links all our sites via point to point crypto maps on a wes circuit, will all these point to point maps be on there own /30 masks, how are these set up with regards to addressing etc ?
Hi guys,How can we disable the visrtual interfaces that are used for infrastructure devices comunication? On ciscoworks we receive many alarms of performance because of that virtual interfaces :( All the 1100 and 1200 APs are configured as root devic...
if a line card in a CAT 6500 is suspected to have an intermittent hardware fault, what is the procedure to run enhanced diagnostics or extended hardware diagnostics on that line card? Can this be run online or only at boot time? Any pointers to any d...
WS-2950G-48-EI switchAll 48 of the 10/100 ports have portfast enabled. I have a dlink dss-8+ switch conencted to one of the port. 2 of my win xp pro workstations are connected to the dlink switch. When I first start up the workstations and log in ...
Hi forum,we are using 3com switches, the 3com switches implement open vlans, which mean if an ieee 802.1q packet is received at a port and the port is not a member of that vlan, the switch does not perform vlan filtering. if the address is previousl...
I have a 6513 with SUP II. I need to get it to Native IOS. When booted from the IOS in slot0 (giving the boot slot0: command in rommon mode), it boots but goes in Router(boot)) prompt. I think it goes to its CAT OS features. What is this prompt? doe...
Dear all,access switch is connected to base switch and base switch is connected to DHCP server, however users are connected to access switch are not getting IP address. Hence i would like to know the solution from experts.I remember there is a comman...
I have 2 switches running at the moment and I want to plug a 3rd in. Will I lose Network Connectivty with the Master and 2nd switch while it synchronizes with the new 3rd switch? or will it not affect anything ?
I have two catalyst 6500 switches running MSFC and FWS. The running applications for the two FWSMs are version 1.1 I intend to upgrade the application software to version 3.1.Without any configs changes. Would this have any impact on my network like ...
I recently upgraded the Memory & CatOS on my 6509 Core Switch. The switch has dual sup1a engines w/ MSFC2 installed. I upgraded to 128 Megs of Memory and to CatOS 7.6.9 from 6.4.21. I now notice a difference when doing a show ver where it doesn't tel...
A HP printer connected to f0/42 on a 3550 suddenly lost connections. The cable and jacks were tested fine. Interface light on the Catalyst looked normal. Hooked a laptop to the wall jack. It auto-negotiated and had a L2 link connection. But no traffi...
