HiPS Examine the following attachment(config+diagram);what could be the Eigrp config from the CORE Side.what network should i advertised?what about the passive interface?
Hi All,Can I bundle Fiber and copper ports into the same etherchannel in Catalyst 6500 series switches?I basically want to create redundancy,ie when fiber goes down,traffic still goes thru copperAll ideas are appreciated.Thanks
Hi is there a way i can erase and then load an ios in rommon I upgraded a 1600 i have and although the flash card is 8mb which was the stated requirement for the IOS it will now not load IOS and says not enough flash memory?So i need to erase it and ...
OK Im really confused. I thought you couldnt have collisions with a full duplex port but yet my switches are showing collisions even though they are set to full. Also I was told that some applications will not run right if the network cards are set...
Has anybody seen it before where a PC is requesting inline power - and then the link flaps because of it? I don't know if it's my 3560 or the PC but I think it's the PC.
Hello, I need some clarification on how to setup l3 switching and intervlan routing with a 3550 switch. The 3550 is connected to 2 switches with several vlan's. Thanks for your time
Hi,Have a client whose IOS 6500/sup720 shows the following output:----------show output--------Core_2#sho spanning-tree vlan 1Spanning tree instance(s) for vlan 1 does not exist.--------------------------------------Config Excerpt--------no spanning-...
I have a Syslog server configured in my network.The Cisco 6509 switch has been configured to send SNMP traps to the syslog server by using the command:snmp-server host 10.40.70.1 publicDo i need to put in the following command as well :logging 10.40....
HiI would like to be able to monitor multiple RSPAN sessions from multiple switches. (for example i have three VLANs I want to monitor on three switches all to have a destination of three Ethernet interfaces) Ideally I would like all the RSPAN sessio...
Hi: I add a NME-16ES-1G-P to Cisco Router 2811. After I add the module I haven't found a way to make the hosts connected in the module to see the router interfaces. Thanks in advance for any help.
Hi, I have a Catalyst 6509 switch. One HP Linux machine and one Solaris machine are directly connected.Gated process is running on both machines for ospf.The problem is some times i see low throughput when i do ftp from linux machine to solaris mach...
I am unable to reach the internet using SSID TKCTS. Everytime it associates it is given a IP 192.168.1.103. However my fastethernet0 connection I have setup as DHCP and I get the correct ip 192.168.112.2. What am i doing wrong. attached is my con...
