Other Network Architecture Subjects

after i have erased the start-up configuration file for 2950 series switch and try to access via console port i cannot type anything , at the same time the the console windows view the switch logging messages , like while the IOS is loading and all o...

I have two 3550's connected, trunking 802.1q, using fiber. I want to install a wireless link for a backup but dont want to manually bring it up and down because I want the fiber trunk to be primary and the wireless secondary. Someone told me to use...

I have two networks that are connected via two 350 Bridges. Each site has a voice and data network. The Bridges are on a third network. The 3560 is doing the routing between all sites. What is the proper configuration for the switch port that the ...

I have a medical device (limited config/testing access at OS level) which connects to the network through DHCP. The device communicates with a PC on the network that collates data sent from the medical device. Data is sent as a broadcast to the PC ...

what do we use these for, are they to stop routes being injected into a routing protocol ? can anyone give me an example ?

Hi allI have a 2900XL core switches which in turn connected to several 2950 switches. All are connected to VLAN 1.I have a few questions:When people say broadcast traffic should not be more than 20% of the VLAN traffic. 1. Does it mean the broadcast ...

on my router have have done a translation for port 100 outside to 21 inside for my ftp, my question is how do people on the outside connect to this, as surely outside it will be looking for port 21 ?

Hi, Just for the information .For 6500 Native IOS u can check the Serial no. of switch by using command "show idprom backplane "regardsAbhishek

Hi,Our network's as follow :router (2611XM) --- switch1 (2950G) ---- switch2 (2950T)We've configured vlan 2,3 on switch1 and vlan 4,5 on switch2.The router do intervlan routing :IP: 192.168.2.254 for vlan2IP: 192.168.3.254 for vlan3IP: 192.168.4.254 ...

Hii have SW1 Connected to SW2 Via stack.sw1 hold vlan 10;sw hold vlan 11/also switch 1 connected to ds1 whaile sw2 connected to ds2.1)i want to do load balance & redundancy between these 2 vlans(vlan 10 go via link to ds1 & vlan 11 go via link to ds2...

HiI was wondering how you look for specific state ports in switches with catOS.For example, we have here a lot of catalyst 6509 full of port modules and every port with port security activated.When a port goes to shutdown, we have to find that partic...

hi there, in a nutshell I have implemented vlans on a cisco switch network. the core 3550 switch can see all vlans, vlans devices can see each other beautifully. The problem is the original 2600 router with an IP of 10.147.8.1 can only be seen by dev...