Other Network Architecture Subjects

First off what limited experience I have have with imaging and multicasting has had to do with single VLAN or WAN implementations of Multicast services.My configuration is as follows:3560G (Acting as the gateway for VLANs 10, 100-1006, 200-206 and 30...

There is a new office being prepared that will house about 15 users and some servers. We're looking at different options for data and phone services, one of them includes Comcast broadband. They will need wireless capability, a firewall, and a site...

Dear allEnvironment Cisco 3550 Switchpls supporttks

Hi,My question is regarding "switchport priority extend trust" question? When I set that command, the mini-switch on the 9760 phone keeps the cos priority of the data traffic received from the IP phone access port, which is great, as supposed to. B...

All,I have a Cat4006 with a router card and I am unable to telnet nor ssh to either of the cards. On the Mod1 (Swtich Card) I am able to console and not ssh or telnet. I recieve a connection to host lost. On the Mod2 (RtR Card) I am able to telnet...

I'm trying to configure a port as trunk (dot1q), but for some reason I only have the choise between two options (access or multi)Switch (config-if)# switchport mode ?accessmultiSo I'm missing the trunk option.IOS Image running : c2900xl-hs-mz-112.8.6...

I have a situation that I was trying to seek some assistance on. At this site, there are 2 Internet connections, 1 T1 and 1 Cable. Right now everything is going out the T1. They would like to add the cable ISP and a PIX 501 for guests and have all...

I am trying to set up my router to forward incoming traffic to the appropriate device based on the incoming port. So that if I typed in 60.61.80.117:22 ? traffic would be routed to my SSH server in my DMZ at 192.168.15.10.Everything else (internet) ...

Hi everyone,I have a question about I understand automatic aliasing is used when inside global addresses in static entriesallocated from unused addresses from an attached subnet.So the router can answer ARP requests for those addresses and packets de...

If im running eigrp on my router between my 2 networks, but have a default route pointing to another network, will it use the default route for everything, or will it still use eigrp for the advertised networks as its more specific, also we have a de...

Whats the command to enable tacacs on initial login instead of having it go to the menu . We already have it for enable mode . Used to know this and there seems to be very limited info on CCO on this old switch. I believe it was just a single c...

I have an issue where switchports configured for port security and mac-address sticky are going err-disabled for no apparent reason. They are not being replaced. They have not been moved. They were working fine for weeks. I can tell you that it start...

I'd like to redistribute a pile of statics on a router into OSPF. However I don't want to redistribute ones that go via a particular router.Would an extended access list with the particular router as the destination do this ?Router ospf 1redistribut...