I'm investigating to see if Cisco will be releasing any patches due to the Day Lights savings time change in 2007. This is due the month it will happen in for the next few years. Will there be a patch release for any known issue with this change? Day...
hi All,I am seeing a very high rate of input errors and crc errors on one of my fast interfaces used for metro e. can this cause a significant slow down in performance? i read online that this could be caused from a duplex mismatch. should I check...
hi i am trying to implement a simple CBWFQ on cisco 3600 and the bandwidth allocation does not work, the 2 sources i use to generate udp traffic towards one source get eaqual share of the bandwidht, the policy maps fail i guess but i think there is n...
I have a cisco 2621 router running 12.1 ios, and I am trying to port foward port 80 back to a Solaris 10 webserver. My router has a verizon dsl modem as dialer and its has a dhcp ip number. I have put this command in the router: ip nat inside source ...
hi all can anyone tell me what the standard practice for isp internet routers are, do they normally use bgp, and where is the next hop normally for them ?
Hello,Anybody using removable ( external ) Flash Memory Card on disk0: of SUP720/MSFC3/PFC3A on Cat6500.Cisco doc shows " MEM-C6K-CPTFL512M " for 512 MB . Is it really for external ( disk0: opening is narrower than the regular PCMCIA card )?Anyone kn...
I have a PIX firewall connected to port11 on the 3524XL switch. The Windows Surfcontrol server (not ISA ver., only has 1 NIC) is connected to port16 on the same switch. The server can see all the traffic going out to the Internet & apply the polici...
Hi,I'm using two MLS 6509. I have configured two FE at each MLS with same stanby 1 (HSRP Group) but with diff HSRP IP address/ subnetCan any body tell me , HSRP priority is per interface or per MLS?RgdsChintan
I can't seem to figure out what is the practical difference and what are the consequences of using multiple secondary IP vs creating multiple logical interfaces?I was wondering if this would bother my router's VoIP functions in anyway?
Hey All,I'm attempting to create a trunk between a 3750 and a Cisco 2811 router (with a 16 port switching module NM-16-ESW). I'm using an etherchannel trunk between the two. I'm trying to configure VTP on the 3750 (server) and make the 2811 a clien...
