I need to remove a configured 3750g out of a 7 unit stack. I want to replace it with another unit that is the same. How to keep the config correct an get the unit into the stack.
when people create vpn ipsec tunnels, do they normally use a loopback interface for peering, and how would I address this ? if I have a serial interface with an ip on, would I need to point the route to the loopback interface via the serial to this r...
Hi folks,got a 2811 router with 12.4 secure ios on it, with an extended named access list that I wanted to edit.The weird thing that I cannot see how to add remark statements where I want them.Some documentation states that you can enter them after a...
I have a problem with upgrade the image of the FWSM of my catalyst 6506 core switch.I have the new image on my laptop which has an IP address of 10.21.17.34 on my LAN and when I telnet into the core switch and session into the FWSM,and issue the "cop...
xx4510xxxx3750Axx xx3750Bxxxx3560Axx xx3560Bxx xx3560CxxI have three 3560 which each have a separate trunk port connected to two 3750?s.The three 3560?s are in different vlans.The 3750?s are both connected via layer 3 links to the 4510.I am using HS...
Can I configure an IOS router to dial out on a scheduled basis? I have 25 sites that I want to dial out every night at midnight and stay up for 30 minutes so I can make updates to the configuration. None of them have broadband and they are all dial o...
Hello,I finished CCNA exam early in May. Now working with a company who deals in routers,switches etc.I recently gone through variety of methods to conifgure, to trouble shoot Cisco router's. I realised there are 2 ways to reset routers original con...
Does anyone know what this process is? and what can cause it to take up cpu resource? thanks.119 2240926416 497350514 4505 71.61% 70.35% 70.69% 0 CHKPT EXAMPLE
Hi,I have a very basic question I wanted to run by everyone to make sure my understanding is correct.Setup:Basic config, router with two interfaces and a single default route. hostname RTR1!interface Ethernet0/0 ip address 1.1.1.1 255.255.255.0!inte...
Is the command ip routing in the CLI the same as routed enable, using Cisco Network Assistant, on the IP address page under device properties? By default it is enabled for the Vlans that I have IP addresses for but I dont see ip routing in the confi...
Hi,I have a WS-X4515 that stays in a boot loop issuing the message above. In which memory the Cat4500 stores its MAC address and is there any possibility to punch it in manually in ROMMON (or do I have to RMA) ?Any hints welcome. Thanks.Mat
