dears, I noticed one of my 2950 both switches is restarting from time to time, the both are performing purely as layer 2, vlans are configured on both switches and propagated through the trunk ports, the switches are both in transparent mode. one of ...
Hi I want to redistribute the connected interfaces in eigrp .The router has 2 gigabit,2 fast ethernet and 8 serial interfaces.How can I redistribute this interfaces that have different bandwidth??Regards IlirThankyou
Hi All, I woud like to know from where I can obtain (SNMP OID) on specific router or a switch in order to view out it's processor or memory utilization?? Thanks in advance,
Hi, Folks:I've been asked this question, and the guys siad my answers were not satisfying.The question is this:You have a network that consists of many swithes--like 40 something, in IOS and CATos. Now you know the Mac-address of a PC but you dont kn...
Can anyone tell me what is the standard for access lists for blocking internet traffic on a router, Do people just have a list just permitting anything outbound and port 80 inbound ? is this right, or do people use CBAC instead ?thanks
Hi,Getting large number of errors on 6500ETHC-5-PORT FROM STP - PORT LEAVING BRIDGE - PORT JOINING BRIDGEconnected devices are apple macs running GigE.Anyone seen this before?CheersScott
If I have a normal 1700 with a serial and 2 ethernet interfaces, can someone give me an example how to put this exchange server in a dmz ? I could do with a simple config as a pointerthanks guys
I want to port forward tcp 1723 and gre 47 to my rras box for vpn connectivity.I have a 2620 sitting on the frontline with ip XX.XX.XX.174/30 (T1). This is already configured for NAT. I need to forward these ports to 10.X.X.200. I have tried ip nat i...
All,I have a cisco 7505 and it keeps restarting. I run a show version and I look at how long the router has been up and below that line is this line "System returned to ROM by processor memory parity error at PC 0x602A3B5C, address 0x0"Is this the re...
Hi,I have a cisco router configured for dot1q trunking (data vlan + voice vlan) on fastethernet interface. This interface is going to connect to a switchport in the catex500. which role should I assign in the catex500 config? router? switch?In this s...
i want to use radius server to record authentications on Cisco routers?users will call a toll-free number through PSTN lines to my Cisco routers where i want to record authentications on Cisco routers to bill. I think to use MySql, Apache, PHP on Lin...
