I have 2 routers connected with OSPF SINGLE AREA 0 Router 1 Int IP as follows:Ethernet0 192.168.1.1/24 Serial0 192.168.2.1/24 Router_2Int IP as follows:Ethernet0 192.168.3.1/24 Serial1 ...
I have an old 6509 with sup 1 and some WS-X6408-GBIC. Now i will upgarde to Sup 720 or Sup 32. I need to confirm if WS-X6408-GBIC ( no A) is compatible with the new sups? specially with the shared Bus limitation on the module.
Setup:R1 and R2 on same ip net.On R1 policy based route is configured with R2 as next hop.Will R1 send icmp redirect (to use R2 instead) to those hosts that match the policy based routing ?Thanks.Gert Schaarup
I am actually migrating one to the other and I have the sup 720 built and a switch connected and have done some tests. But to exercise this more I was able to create a trunk port on each 6506 and come up and ping different things and all was well. ...
Experienced a problem with a 6509 chassis that the recommendation was to upgrade the rommon level on the sup720s which have msfc3 and native IOS. I have a procedure that shows an upgrade of an individual supervisor and a procedure for upgrading an M...
Hi, i wanted to trunk between cisco 3750 & SGI 350 Series Server, is it possible, so how do i trunk between these two? i know the trunking between 2 switches.
I'm running a Catalyst 6513 switch with Native IOS installed. I have created a EtherChannel bundle for an HP Blade server running with two clustered (teamed) NICs. The configurations are as follows:interface Port-channel100 no ip address switchport s...
Hello, I have one 6509 CATOS version 8.1(1).Below are the utilization of the switch.sh sys...disable 9600 6% 11% Mon Nov 28 2005, 13:15:10...sh proc cpuCPU utilization for five seconds: 57.60% one minute: 53.39...
I have got this scenario like this Switch1: vtp domain DOGCAT vtp password CISCO vtp pruning vlan 3,5,6,8,10,26,33,52 Switch2: vtp domain DOGCAT vtp mode client vtp password Requirement: VLANs not locally assigned should not be received over any trun...
Hello!I'm running cisco 7507 and have a problem with netflow v5 and nat.After 2-3 days Netflow engine stops collecting incoming traffic for ip addresses whis are translated.Sh ip cache flow stops showing theese packets.I tried debigging netflow and h...
Hi,I have CE-500. There are users which have IP phones with atached desktop PCs. So their ports have role Desktop+IP phone. Security is set to low, so for each port there can be 3 MAC addresses.Some users are running VMWare which creating additional ...
Can anyone tell me why we have to have a dial in address on our radius server for our dsl lines, the ip of the dsl router would be say 172.28.101.1, and the ip on the radius would be 172.28.101.2, why do we do this ?
