Other Network Architecture Subjects

Hello all,We have 3750 already working as a single switch. I have another one coming in with virtually empty configuration. How can I set up cluster with no/minimum downtime for the first one ?By the way - is there a "quick" way of wiping out configu...

I am trying to set up the default ftp username and password but get the following error. Can't see any reason for it and checked the manuals. mensa# config tEnter configuration commands, one per line. End with CNTL/Z.mensa(config)# ip ftp username c...

I have connected a 9216i to the uplink port of the SUP 720 card in a 6509-E Cat Switch, and have configured that port for Vlan 2. But I cannot ping the 9216i. I have created a trunk port to a router for Vlan 1 and 2 using dot1q. Interface says connec...

Hii need to add a vlan for video and i want to restric the bandwith for this vlan, i mean i want that the application of video don`t use so much bandwith, is that posible do it? and how can i do itregards

hi all,we had a serious error while upgrading an catalyst 6500 with MSFC2/PFC2 from catos to ios.the error occurs when we boot from the flash-disk for the first time with ios. the switch-processor seems to work all right - it looks like that the msfc...

Trying to access a EtherSwitch Service Module within a 2811 , i believe the module runs its own ios, have found "service-module g x/y session command"but am still having no joy any one out there come across this issue before

From the sh platform port-asic stats drop command, we are able to see the drop stats for the master switch. Question 1: how can we see the same stats for the stack member ^Question 2: Is that possible also to consult the drop stats for the 2 x ring. ...

Dear All, We are having 2 internet link from 2 separate ISP. Please help me in doing load balancing on this 2 ADSL LINK. Thanks/Regards Atul

Can anyone tell me why my router had a dhcp address on it when I booted it up, what would be the point of this ?

Can anyone please tell me what the inside local, global, outside local, global meaning are, I have looked at an article but dont get what it means ? also I have seen a command on the nat statement that says extendable, can anyone tell me what that ...

Can anyone please tell me or point me in the right direction of the correct ios for creating vpn on my router ? My current ios wont let me do any crypto maps etc !!thanksCarl

Hello,I have (2) 6509 switches with the same hardware setup and config, including several X6516A GBIC blades. There have been two instances over the past few months, where these switches were rebooted. Both times, the x6516A GBIC blade in Module 2 ...

Cannot connect to the above switch from my console port. Port not working. I don't have any I/P Address on this switch that I can Telnet into. Is there any way I can connect and setup an I/P Address??

Hello,I was wondering if there is anyway to automatically drop a router interface if another interface fails. I'm trying to tune HSRP, but it will not work properly if I cannot disable my WAN interface if my LAN interface fails. Any ideas?Thanks!!Lee

I have problem with mac address learning on C3750. I need to connect two vlans on the same C3750 by external L2 box (IPS device). This box provides mapping between vlans on trunk ports. Connection is depicted below:int vlan 370 (L3 svi interface)...