Other Network Architecture Subjects

Hi,I have a network with 3 switches. I'm using vlans and I have problem with out WS-C2950-24 type switch.I'm not able to put the switch's vtp status in server mode. What could be the problem? The other twoswitches are in server mode. Thanks for your ...

Dear all,We would like to enable flow control on CAT6500 switches interface but before that we want to know how its works and you know more about it, So, please let us that where can we find appropriate documentation for the same.Please provide us th...

pls. help me on how to configure or to determine the IPs of each work station, give me some examples. thank u very much.

hello everybodyi need explanation for this commandi read about it, and i didn't realy understand.first the syntax:if my router is run ripso i get in: "router rip"and then i said advertise my table with all routers that run ospf AS 1 like that:router(...

platform: C2500IOS:11.2(9)environment: two routes running ripphenomenon: when the metric of a redistributed connected linke on one router became large, such as from 1 to 2, this route on the other router changed from 1 to 2 immediately instead of ent...

Hi everyone,Customer configured Dynamic NAT as follows,ip nat pool IPPOOL 210.88.113.224 210.88.113.254 netmask 255.255.255.224ip nat inside source list 20 pool IPPOOLaccess-list 20 deny 210.88.112.96 0.0.0.3access-list 20 permit anyAbove NAT pool ...

I've got a new 2948G-GE-TX and am wondering if there is an available web interface version to download. When I do a show ip http, the web interface version is empty. Is it an option on these type switches and if so do you know where Cisco has the s...

While not the administrator of a network employing Cisco hardware, I am currently a victim. Ever since my university has switched to Cisco switches (routers?) for all living facilities, many popular games such as Counter-Strike and Battlefield 2 have...

Hi,What version of IOS should I use for a Catalyst 3750? I don't need layer 3 functionality, but I do need SSH support. Which version is the most stable? Can I run the 3750 off a bin image instead of a .TAR image?If I do use the bin image what functi...

Hi, I'm trying to convert a switchport into a L3 port in a 4507R running IOS Version 12.2(20)EW, but when I execute the command "no swtichport" it displays the following message: "Command rejected: Not a convertible port."-----------------------Sw2-L...

My company is upgrading our T1 wan to a Metro Optical Ethernet (MOE)from our service provider. At our main site we will be connecting to the MOE via a 7206-VXR NP-G1 at gig speeds. Other remote sites will be connecting to the MOE using one of two m...

Platform : C6500+SUP720+122-18SXE1How can I disable igmp version 2 globally ?without breaking ipv4 multicast ?no ip igmp version 2, seems doing, but does nt disable igmp either globally or on an interface.Best RegardsFlorence

hello, first sorry for my bad englishi just wanted to know how configuring PAT (port address translation)like this :?amir(config)#ip nat inside source static tcp 192.168.1.1 1000 172.16.1.1 1000or not?2nd question i have is:when i need to write: "ip ...