Physical Security

Hi ,I am facing a problem with VSOM 6.3.0 .It is not working with Windows 7 .Any idea ?

Hi,Has anyone seen the following error: Cannot reset proxy server. Failed to send MSG_RESET to proxy p_1WH-CAM_161WH-CAM_16 is the camera name.  All we are trying to do is update the authentication details within the admin software.Is there any way o...

I'm looking for a few suggestions on known working video cards.  Accroding to the specs listed in: http://www.cisco.com/en/US/docs/security/physical_security/video_surveillance/network/vsm/client/VsmWorkstationBaselineSpec.pdfThe card listed is the N...

What is the Maximum number of gateways that you can run off of a single server? Thanks.

Has anyone successfully made a service cable for the 5010 / 5011 Cisco IP dome cameras?  We are looking for the 2.5mm stereo jack to BNC connector and have found a pelco service cable IS-SC but it is RG174A/U and not the required RG174/U (not sure if...

Dear All, I have 2 nos 4 RU servers and 1 2 RU server ,  one is main and one is back up, I am going to install 200 Cisco indoor 2421 cameras.  while making confirgarations I had logon to back up server and did 20 camrea configarations. But i asigned ...

Posting this to potentially avoid this pitfall for others in the community.Symptom:  When upgrading a Cisco 5000 series or 2900 series camera, the firmware upgrade fails after a few seconds or minutes.When using the firmware tool inside VSMC:It attem...

Hello Fellows,I have been trying to figure out which camera models support internal storage to archive video streams in case the network path to the video surveillance media server goes down. Can someone help?Thanks.Moath

I have exisitning VSM servers and may need to fully qualify the domain name (basic name) of the servers. Will the added information (new to the server) effect the operation of the VSM software?

Hi,   I was just trying to confirm if a time sync between the CPAM server and gateways was automatic or if there was a procedure involved. NTP is setup on the server, and the documentation mentions syncing their clocks, but did not see anything that ...

Hi, I am trying to locate a list of supported cameras for VSOM.I have an Axis P5512-E PTZ that I am trying to add to the system.I had to choose Axis 2130 PTZ and the PTZ works but I am unable to get the presets to work.Thanks for any help!

Does CPAM require the web services licensing to allow URL commands to be sent to VSM?  I have device commands working as they should, but still cannot pull up video when a URL Automation Rule is invoked.ThanksM

I am using VMSS (Video Managements and storage system) version 6.2.1.I tried to record a camera feed using Cisco interface i.e "Video Surveillance operations manager" and I have tried to play back the recorded stream. But its not playing. I have seen...