Hi , The network status of our both virtual appliances is showing as imported : 6 months ago . Also , it shows its status red. Can anyone please tell what is means.
Forum Posts
Hello, The goal is to route all traffic coming from VLAN200 via ASA VTI tunnel. In this case, I wanted to apply PBR at ASA Group-Channel Interface and to use VTI Peer IP as next hop. Please see information below. Any help is much appreciated. 10.2...
Hi Guys, Hi Guys how can I find these? Specifically CPU & Power Supply temp thresholds? Thanks Kris
Customer with a single router and private IP subnet behind router. Requirement is to add high availability using two ISP's and BGP. Inbound services for HA would just be web servers. Public IP's are /28. My questions are: 1. For outbound conne...
I have been looking for the reason why R4 doesn't show R1 and R2 loopback IP addresses on the routing table. The R1 & R2 loopback IP addresses are seen on the OSPF datebase as Router Link State on the R4. However, It shows it's unreachable when check...
We have an ASR 9001 with the following active packages: disk0:asr9k-mcast-px-5.1.2 disk0:asr9k-mgbl-px-5.1.2 disk0:asr9k-mini-px-5.1.2 disk0:asr9k-mpls-px-5.1.2 We want to upgrade to the recommended version 6.3.3 and also enable SSH on the ASR. Is ...
Resolved! BGP TCP Session
Hi Can anyone tell how to find which router first initiate the TCP session in BGP. Thanks in Advance.
Hello, Is it possible to influence outbound iBGP route ? AFAIK as-path doesn't work. MED too ?
I have a question regarding VRF-Lite. One of our customers wishes to run a number of different VRFs on a Catalyst 9500 switch. On more than one of these routing interfaces NAT is required. They have purchased DNA Advantage licensing but are unable to...
So I created another vpn to encapsulate all traffic, I need to be able to replace the VPN CLient Wan ip with my corporate IP. Also when the vpn client is connected i can lookup dns but not ping the address.
Resolved! iBGP Advertising Architecture
Hello everyone. I'm currently designing a BGP scenario for my data centers. Basically I've got the architecture attached. Information: I'm receiving full table from both my providers on both my data centers. I have iBGP between all border route...
Hi everyone! I got an issue with the configuration on Cisco 1841. I have two pppoe WAN, and config IPSLA to run failover. But when the ISP-1 down, I can't connect to the internet through ISP-2. Here is my full configuration: Building configuration......
Resolved! IP Helper Redundancy - HSRP
Hello, I have two ASR 1001X routers configured with HSRP and IP helper addresses on the interfaces for DHCP address assignment. I'm currently having an issue that's been observed when two routers in HSRP, configured with helper-address forward the...
Hi Experts, Please give us some suggestions. I'm running a couple N7K as campus's core. Separate two LC on each box to TWO VDC e.g. Backbone & Wireless VDC. Wireless VPC is paring to 4 WLC, 2 links each. Between N7K and WLC running in layer 2 mode. W...
