Routing

We are currently redesigning a network for a small-"ish" college campus and have landed on routing to the access layer using OSPF on Catalyst 3750G switches. We use Ubiquiti Unifi Access Points and plan on keeping it that way for financial reasons. S...

Hello I have a problem with my cisco catalyst 3650 L3 switch (IOS-XE software, software CATK3K_CAA-UNIVERSALk9-M, Version 03.07.04E RELEASESOFTWARE fc1) I want to configure a routing protocol like ospf or EIGRP but the commands doesn't exists. you ...

In our company we have a Cisco RV016 router that we use with 4 WAN links: one optical fiber link and the other three are PPPoE links.For a long time I was able to make this router work with the 4 links simultaneously balancing load between them.Howev...

Hi again! I have many stacks of 3850-12X48U-L Switches with SW 03.07.04E. I discovered many Ports that show a higher error rate than they actually receive packets: switch#sh int GigabitEthernet1/0/1GigabitEthernet1/0/1 is up, line protocol is up (co...

Hello, I'm facing a strange QoS issue on ASR1001 router (IOS-XE image - asr1001-universalk9.03.13.06.S.154-3.S6-ext.bin). Topology is pretty simple: <VOICE INFRA> ---- (Gi0/0/2) ASR1001 (Gi0/0/0) ------ <WAN> I have interface Gi0/0/2 connected to a ...

Hi Anyone can explain the below bold-highlighted output of command show ip route 10.10.1.1 vrf EEE in Nexus7K? Thank you 8E# sh ip route 10.10.1.1  IP Route Table for VRF "default"'*' denotes best ucast next-hop'**' denotes best mcast next-hop'[x/y]...

How to install and configure Expansion Module on a Cisco 7961. Where do I go to configure Internal Speed Dial Numbers on the Expansion Module

I have multiple client networks that I need to WAN between the same locations. The multiple client networks are separate and should not communicate with each other.  What is the router / DMVPN configuration for this effort.   Thanks Byron

while reading a multicast case study I read one of the requirement that should be asked is  : " how many groups are required while configuring multicast in network "  what should i imply with this statement ?

I have a Cisco 3925 on 15.01.  I'm attempting to allow machines on the Engineering network to access a webserver on the Management network on VLAN10 through a Static NAT.  The webserver on the Management network is configured for 192.168.1.125.  Any...

i'm in the midst of wanting to move a school system off a 3750 switch in which i'm using qinq to connect 7 buildings.  I obviously preserve the vlans between the building.  I want to move these connections to an asr9010 which obviously uses ios-xr vs...