Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

“Webinar

 
Labels

Forum Posts

Where to apply policy-map when GRE Tunnel Interface have "tunnel source Loopback" ? - to Physical interface (corresponds to a routing table for GRE IP header DestIP)? or - to Loopback interface? Example. Where to apply policy-qos-test-parent: polic...

Hi All, We have cisco 2921 routers as WAN router at each of our branch offices. I am in middle of a design to enable DMVPN over Internet among these routers. As a prerequisite check, can you please let me know whether 2921 fully support DMVPN with O...

Turbo727 by Level 1
  • 633 Views
  • 1 replies
  • 0 Helpful votes

Hello Experts - What is the method I can use to find the Top Talkers / IP route-cache flow in Cisco 3560-E or 3750-E platform. The reason for asking is, as per below document from cisco, these commands are not supported. http://www.cisco.com/c/en/us/...

Hi Guys, I need some assistance. we have a Cisco ASA as a perimeter firewall, and a our ISP has put down their CE router. We have been given an IP block, and the gateway. The way I understand, and have configured previously is that We have a stati...

krillin21 by Level 1
  • 345 Views
  • 4 replies
  • 0 Helpful votes

Hi, I am stacking some 3650s together.  After stacking them I noticed the active switch, standby switch, and member switches.  I understand that the active member controls the stack and keeps the configuration file and if that switch goes down the s...

lkadlik by Level 1
  • 14267 Views
  • 3 replies
  • 0 Helpful votes

i need your help regarding this question: Refer to the following configuration command.router(config)# ip nat inside source static tcp 172.16.10.8 8080 172.16.10.8 80Which statement about the command is true? A. Any packet that is received in the ins...

HIACI-711 by Level 1
  • 535 Views
  • 2 replies
  • 0 Helpful votes

According to the BGP Best Path Selection Algorithm: Paths from an external BGP (eBGP) neighbor if the local autonomous system (AS) appears in the AS_PATH. Such paths are denied upon ingress into the router and are not even installed in the BGP Routin...

Resolved! Can not pass IP

I have a stack on 5 C2960x-48LPD-L. I am in a network of /16, /24, and /23 I am configuring the stack on a /23 I have a VLAN setup on the router with the /23 and the same on the stack I can get to the Stack by the vlan on the router but not directly....

Hello Guys - I am using a 3560E switch with IOS version 12-2_55_se (Universalk9). Though i am seeing the command "ip accounting" under IP interfaces, "show ip accounting" doesnt show any entries. Also the command reference guide doesnt show the guide...

Good evening all together, I have a question.  I saw a configuration of a router. When I send the command "show ip int br" I get a vlan with an Ip-address I never seen that before. I know that you "normally" use subinterfaces to do the intervlan-ro...

jennybe by Level 1
  • 500 Views
  • 3 replies
  • 0 Helpful votes

Does any IOS or IOS-XR version support RFC 6232? If yes then which version.  RFC 6232 is not listed in below URL for IETF RFCs supported in Cisco IOS and IOS-XE Software Releases 3.3S, 12.4, 12.2SR, and 15.1 : http://www.cisco.com/c/en/us/products/co...

Review Cisco Networking for a $25 gift card