Routing

Hello, I'm facing a strange QoS issue on ASR1001 router (IOS-XE image - asr1001-universalk9.03.13.06.S.154-3.S6-ext.bin). Topology is pretty simple: <VOICE INFRA> ---- (Gi0/0/2) ASR1001 (Gi0/0/0) ------ <WAN> I have interface Gi0/0/2 connected to a ...

Hi Anyone can explain the below bold-highlighted output of command show ip route 10.10.1.1 vrf EEE in Nexus7K? Thank you 8E# sh ip route 10.10.1.1  IP Route Table for VRF "default"'*' denotes best ucast next-hop'**' denotes best mcast next-hop'[x/y]...

How to install and configure Expansion Module on a Cisco 7961. Where do I go to configure Internal Speed Dial Numbers on the Expansion Module

I have multiple client networks that I need to WAN between the same locations. The multiple client networks are separate and should not communicate with each other.  What is the router / DMVPN configuration for this effort.   Thanks Byron

while reading a multicast case study I read one of the requirement that should be asked is  : " how many groups are required while configuring multicast in network "  what should i imply with this statement ?

I have a Cisco 3925 on 15.01.  I'm attempting to allow machines on the Engineering network to access a webserver on the Management network on VLAN10 through a Static NAT.  The webserver on the Management network is configured for 192.168.1.125.  Any...

i'm in the midst of wanting to move a school system off a 3750 switch in which i'm using qinq to connect 7 buildings.  I obviously preserve the vlans between the building.  I want to move these connections to an asr9010 which obviously uses ios-xr vs...

Good day to you all. I currently maintain a scheduled backup procedure for my IOS switches via kron. However we have some SG200 and SG300 devices about the place. Are there any builtin processes (like kron perhaps) in these switches that allow for au...

Hello,  We're considering replacing our distribution switches (C6509-E) with C4510R+E Chassis. We're considering to get the IPBase license for these C4510Rs. I understand this license only provides the EGIRP Stub feature. Our current topology involv...

We currently have a few DMVPN sites with no separate Vrf for default routes or internet traffic. What we do  have is EIGRP running between the hub and spoke and only allowing internal networks to be advertised via EIGRP and  a static default route go...

I have 4 sites that are connected to each other over WAN links. The interface speeds are 100 Mbps, but the Wan link is only 20 Mbps. The sites do not have ip phones, but they are getting one Avaya control unit at each site. These control units will c...