Routing

Hello Cisco experts  kindly , any Configuration example with RPL for BGP multihoming routing manipulation  thanks all

Dear users, Situation: On the left i've got an asa (asaL) and on the right i got another one (asaR). These asa's are connected to eachother using site-to-site vpn. I can access a network on asaR when I am behind the firewall of asaL. However when I...

Hi Guys, i have many questions about some concepts at BGP 1- what the meaning of Autonomous Systems .... and i know the official definition of it but i still don`t understand exactly what it`s     and is AS related to physical location or not ...... ...

Has anyone ever seen a network cable be the cause of a layer 2 issue when your interface on your switch is UP/UP, no input errors you have outgoing packets however no input packets from the server? From my experience when your you're interface is up/...

I'm planning a RSP720-3C-GE to RSP720-3CXL-GE upgrade for a 7606-S (dual sups), and I'm wondering what would happen if I plug a new XL RSP next to an existing non-XL - would it not power up at all?  would it power up and become the redundant RSP (eit...

Hi, I try to set a dual wan system on a cisco 1801 with two adsl, one on the inside modem and one on a external modem connected with ethernet. My config work only with the line connect on the internal modem. Can you help me?

Hi there, The problem: i have my BGP AS, and i make ibgp peering between R1<->SW<->R2 and i am using  for this my BGP AS network segment. In general this is dual multihoming. R1 - my main router. R2 - backup. at my SW - there are my BGP AS which pres...

Hi all, I have the above topology for new project objective is as follows we have two vlans say Vlan 10: 10.232.22.0/24 and vlan 20: 10.232.23.0/24 Requirement is to route vlan 10 via ISPA and vlan 20 via ISP B In case ISPA fails VLAN 10 should go v...

Does anyone know how to get around Mollom blocking me from a post.  If I try to say anything except that they are blocking me it gets blocked

Dear All,Am using 867VAE-W-E-K9 router at home for ADSL purpose and WiFi. But the Wifi singnal is very very low and i don't use any other device with wifi enabled. Is there any way that i can improve the signal strength?? Kindly share your knowledge....

Show IP ospf events  ABCD# show ip ospf event OSPF Router with ID (1.1.1.2) (Process ID 100) 1 May 20 21:35:31.495: Bad pkt rcvd: 172.19.122.8942 May 20 21:35:31.475: Bad pkt rcvd: 172.19.122.9043 May 20 21:35:31.351: Bad pkt rcvd: 172.19.122.9054 Ma...

Hi, I want to interconnect Headquarter and multiples site with DMVPN. It's OK for the configuration but here I should use a routing protocol. Basing on your experiences, what do you suggest to me to use EIGRP or OSPF ? (I will configure a direct Spok...