Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

 
Labels

Forum Posts

I'm configuring an 887VA router's fastethernet0 interface.  What I want to do is trunk all VLAN's from this router to a cisco 2960 switch (or any other access layer switch really).I'm seeing that there's a limitation on this 887VA of only being able ...

What is the best practice for inserting a gateway (default-route) into my ospf network.  I'm currently connected with three Internet connections from two different ISPs on two different routers.  These two routers talk to my internal network via ospf...

jwilde by Beginner
  • 1403 Views
  • 11 replies
  • 0 Helpful votes

Hi, We are expanding our office to another floor (2 floors down) in the same building. We will be needing 8 switches on the new floor office which will connect to the existing office's switch (Catalyst 4500).I need suggestions on the switches.The swi...

Hi, I have a dmvpn network, with multiple spokes.One of them, needs to have a local break out to the internet. Wasn't able to find a configuration example, so maybe if someone could show how to config it.Basically what I need is a split tunnel config...

Hi everyoneim trying to configure redundancy between 2 interfaces on the same routerin one port its' point to point and the other one its ADSL dialer how can i do itright now its a static route 0.0.0.0 to the dialler and i configured metric 10 for th...

Hello!I ask your advices! I have Cisco 881, which is connected to the Internet. There is a VPN-tunnel on it to a host. command "Ping" from 881 to this host is working. But from the PC behind the cisco is not going.I see the Internet, but not the host...

Hi every  my name is gabriel and i am in just about to do ICDN1 . I have a question since i am still new to the Cisco world.When you configure PPP on a cisco router and you want to change the authentication username and password..How do you do that w...

>>rommon 1 > cookie>>WARNING: Cookie information is corrupt>>>>cookie:>>00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00>>00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00>>00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00>>00 00 00 00 00 00 00 00 00 00 0...

Dear all,I was going to replace a cisco 1721 router with a cisco 1841 router. I made a backup of running configuration on 1721 and use a console terminal to made that copy the running config of the cisco 1841. The router have 1 fastethernet card and ...

Hi AllIs a chassis reload needed for this, what is the symptom for the interrupt code.NAME: "module 4/0", DESCR: "Channelized DS3 - single wide, two ports"PID: PA-MC-2T3        , VID:    , SLOT 4/0: %BACKPLANE_BUS_ASIC-4-DEV_RESET: Backplane Bus Asic...

CPU utilization for five seconds: 97%/95%; one minute: 97%; five minutes: 94% PID Runtime(ms)   Invoked      uSecs   5Sec   1Min   5Min TTY Process   1     2612932   3551909        735  0.08%  0.18%  0.16%   0 Chunk Manager   2      280656     64397 ...

hegefd by Beginner
  • 638 Views
  • 10 replies
  • 0 Helpful votes