Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Hi,I am dynamically applying PBR to a virtual-access int via AV Pairs.However not all traffic that should be policy routed is being, some is rejected and normal routed, If I remove CEF from the virtual-template nothing is PBR'd so it is definitely do...

I have my wan modem, then a 45 meters of rj45 cable, till a switch, where connetc two accespoint, they only work fine if my modem is dsl, when wan modem, the data signal from access is interrupted. I Do not know a lot, but, suspect  between my accesp...

buzon0001 by Level 1
  • 252 Views
  • 2 replies
  • 0 Helpful votes

Hi everyone, I am looking for a two Cisco router for entreprise edge network (HA) interconnected with STM-1, which should have the followinginterfaces(modules/SPAs):1/ Electrical interface:   Interface électrique – 100Base-TX ( 8x 100base-TX)   Inter...

ahr139401 by Level 1
  • 1627 Views
  • 8 replies
  • 0 Helpful votes

hi all, my ISP is providing internet via a coaxial cable and Internet modem. It has one Public IP Address assigned. Now i was reading about various types of NAT. My question is if i have 1 Public IP and few internals hosts (with Private IP's ) how th...

Hi all,  I need to enable MPLS on my 7600 router sub-interface, do i need to enable MPLS on the physical interface as well? or it would work with only enabling it on the sub-interface.   thanks in advance 

HiWe have a few sites and currently we have purchased MPLS from the ISP to provide connectivity between the sites. The ISP is in the process of installing the lines at each site and they have provided us with a /30 public subnet for each site, on e o...

881 returned from the field due to wan connectivity failure.  large number of  881's still deployed with no problems.  config has been reset, just basic ip setup now.  FastEthernet4 / FE WAN interface will not remain up - sh / no sh brings it up for ...

wayfaring by Level 1
  • 1677 Views
  • 2 replies
  • 0 Helpful votes

Hi,My goal is to cause a traffic route changes to secondary path when RTT/Latency threshold violation occurs in the primary path via EEM or PBR. I found that router is able to analyze RTT on the primary path via IP SLA ( ip sla reaction-configuration...

Amir.csco by Level 1
  • 1331 Views
  • 3 replies
  • 0 Helpful votes