Buy or Renew
Buy or Renew

Routing

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
Labels

Forum Posts

Start a conversation

BGP Routing Loop of locally advertised routes

So I have seen this happen with multiple customers, multiple carriers, multiple IOS versions, ISR G1 and G2. These are simple MPLS networks with BGP peering to the provider. I am advertising locallly connected routes into bgp. My normal BGP config lo...

mloraditch by • Level 7
  • 2203 Views
  • 11 replies
  • 0 Helpful votes

IBGP Route Reflection Question

What is the point of having the command <no bgp client-to-client reflection> and route reflection at all when ibgp clients in a cluster are fully meshed? If the RR is supposed to minimize the need for full mesh and the clients are fully meshed anywa...

3925 SPE change

Hello Is it possible to change the SPE of a 3925 (SPE100) to an E series SPE 3925E (SPE200)? I want to keep the chassis but want to turn the router into a 3925E.thanksa

Resolved! 887va ADSL Configuration

Hi All,Bare with me here I am very new to Cisco routers.We have currently bought a new 887va Cisco Router to replace our Zyxel router.Our hosting provider sent me a configuration file to use for the router (see below), but I can't seem to just get an...

Resolved! WIC-4ESW upgrade on 1700 series router

For years I've had a simply NAT-based routing set up with the ISP  coming into the 10BT WIC card on my 1700 and then sharing that  connection out to my LAN via the integrated FastEthernet port.I've found that that my ISP has increased my  connection ...

endonesia by • Level 1
  • 2898 Views
  • 4 replies
  • 0 Helpful votes

Resolved! IP SLA ping track with "negative trigger"?

Hello!As far as i understood the IP SLA can ping an interface of a specific router automatically. Then the track in a route-map, e.g. "set ip next-hop verify-availability 3.3.3.3 track 10" take care and if the IP SLA says "status up", then "next-hop"...

MTUnIPMTU

Hi Team,What is the diddrence between MTU and IP MTUPFA, in that MTU can be configured to <1500-9216>  MTU size in bytesIP MTU can be configured to   <68-1500>  MTU (bytes)and even for sub interface i could not able to change the MTU alone without c...

Resolved! Cisco 2901 and BT Infinity

We have recently had BT Infinity installed, we are swapping out the homehub for a 2901 and an ASA.I  am having some trouble with the router side of the config.  My  interface shows as up and is getting an IP address but I cannot get to  the internet,...

Dialer Interface - High Total Output Drops

Hi,Can someone give me some links to Dialer Interface info?I have some issues with my Dialer 1, having lots of Total drops.My internet connection is broadband (10 Mbps) using fiber,interface Dialer1 description *** DIALER-1 GROUP-11 POOL-111 ***$FW_O...

Load more