Routing

ip nat inside source static tcp 10.0.0.3 80 86.96.201.7 80 extendable

hey all.I have two routers connecting to two upstream ISP's...(Im an ISP myself) one primary one secondary. The two routers have the exact BGP configuration. i recently configured local preference on the routers with one set to 150 and the other at d...

Hi guys,I have a pair of CSR1000V running in a vmware infrastructure. I have a slight issue with FHRPs, I tried both hsrp and vrrp and symptomps are the same. When preemption is enabled, the router preempt and becomes active, but the other one stays ...

Hi, I am trying to test a configuration that uses expanded extended community lists, the aim of the config is to block out a range of RTs.  ;The range I need blocked is from RT I was planning to use an expanded extended list and a route map, a route ...

Hello all,I've been beating my brain over a problem with my Cisco 1751. It serves as my ADSL modem and external router for my network.The problem is this:Windows and Mac OS X machines can consistently access Internet sites through it, as well as bein...

Hi, Have a G1, with one active Gig port in a portchan (Second member is currently disconnected, but is also a Gig port on the G1) - No other ports are configured as member ports.Gi0/1 (Active member) has an mtu of 1998(As does innactive member port) ...

Hi. From the cisco press I read:If the LDP peers agree on the session parameters, they keep the TCP connection between them. If not, they retry to create the LDP session between them, but at a throttled rate. In Cisco IOS, the LDP backoff command con...

Hi Everyone,i am not able to login to my ASA firewall via ASD, SSH or Telent. Everytime i have to restart ASA to login , it works fine for some days then again behaving the same. can anyone give me the solution.MODEL : ASA-5502IOS VERSION : 7.0thank ...

am ISP and i  want to test my maximum bandwith capacity that i recieved from my ISP , how can i set huge load to test my capacity ,

Hi,I am seeking a quick expert input that can I use IMA-ATM-E1 card for terminating ATM E1 link in Cisco 2851 router.If yes, then is there any specific minimum IOS version requirement.Thanks.Regards,Arun Seetha

Hello,I have two sites connected to each other with pseudowire with l2tpv3. I am able to ping hosts on both sides. My task is to stream media from one side to another. The software works, because I am able to stream with TCP (RTSP). But when I switch...