Routing

I'm new to cisco and I'm seting up a Cisco ASA 5510.I did the setup for my public and private interface.From the management software I can ping any outside domain using my public interface, but when I try to do that from my private interface I cannot...

Hey everyone, I have a weird problem where two spokes stop talking to each other until I go in and issue a "Clear ip nhrp" command.For example:Today, I couldn't ping from a router in Toronto (10.10.200.11) to a router in Thunderbay (10.10.200.38)Belo...

Hi GuysI have an issue with a site-to-site VPN tunnel between a ASA5510 and 887VA.  I  have two tunnels connected to the ASA and one seems to be affected where by the tunnel is disconnected and brought up around every 20 seconds.  The tunnel is re-es...

I am trying to setup the following.I want to have all Internet traffic to go through ISP2All Corperate traffic to go through ISP1If ISP1 fails I want the Corporate traffic to go through a VPN tunnel over ISP2If ISP1 comes back up and after a couple h...

Hi we need to translate x25 packets to a tcp stream. The translation works fine but our electronic payment terminal application has problem with the received data stream from the router. Our router sends in front of the application data a 4 byte QBit...

Guys I was not sure if this should be in the LAN section but I gathered that as the communication was over two remote sites I would post under WAN.A customer of our has two remote sites both internet facing with a 3 layer design and 2Gpbs inter-conne...

Hello frineds'I have one cisco acs server verson 3.0 and i want to enable mac binding in my all cisco switches in my network through radius.Any one have idea to implement to my network.if you have any document ,pleaease share with meplease tell me th...

Attached is a rough Network diagram of what I want to achieve but cant find a way:A client over the internet connects to 216.1.2.2(internet IP on R2) but this gets automatically redirected to 216.3.3.6(internet IP of Server on Lan behind R1) so they ...

Obtained a 3G ISR C819HGW+7-N-K9 for use as a backup device for Warehouses in Australia.I have followed (and tried) most of the discussions I can find in the manuals and online for getting the 3G operational - without success.The SIM has been tested ...

i want to enable a port 7000 and 514 on my cisco 851w router.using the command-line?Thanks for any help.

Hi, we have a model CISCO857W-G-E-K9  with IOS version 12.4(15)T17We're trying to install Cisco Configuration Professional Express 2.7 and in particular the package cisco-config-pro-exp-admin-k9-2_7-en.zip following the install guide we found here T...