Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

We have a customer, who has the following setup:ISP router with ip range: x.x.202.1/ 28That is connected to a Cisco 2960 switch, that doesn't do much but:Vlan5: x.x.202.14 /28Port 1-12 is switchport mode access to vlan 5There are 3 firewall's connect...

benjamin- by Level 1
  • 841 Views
  • 2 replies
  • 0 Helpful votes

                   I am looking to contain the advertisement and subsequent redistribution of a subnet by use of a ip prifix-list and distribution-list.  My question is, Within the specific router eigrp definition of my configuration, if I am redistr...

Hello,      I have a paclet flow issue and I know its due to MTU size over ip/vpn. I need to know the optimum size of the MTU size. Check the trace log from the router and let me know ..:HEAD.OFFICE#pingProtocol [ip]:Target IP address: 192.168.188.1R...

Hello, I want to know which of the avaliable Power Supply on the RPS 2300 I must choose for the appropriate working of the basic Router 2911 (without PoE functions):1. 750WAC power supply2. 1150WAC power supplyWhich one of the above PS is the recomme...

I saw the reply to this post:  https://supportforums.cisco.com/message/3761251#3761251 and I just  wanted to know what the configuration would look like on the ASR. My main purpose for using a bdi interface will be routing  [ospf] (almost like router...

Hello every one,what is routing redistribution, for what we use it, why we use it and what it do???i have seen this commandes on EIGRP configuration redistribute connected metric *** *** *** *** **** route-map EIGRP_CONNECTED_OUT redistribute connec...

What am I missing...DEFINE MONITOR PROBE:(config) ip sla monitor <monitor#>(config-sla-monitor)# type [echo] protocol ipicmpecho <target-ip> source-int <int>(config-sla-monitor-echo)# timeout <ms>(config-sla-monitor-echo)# threshold <ms>(config-sla-m...

Resolved! Inverse ARP

Folks,Please help me out here.  Where does the Inverse ARP run - in the frame-relay switch or in the attached router?Also, when static mapping is configured, does it simply turn off the Inverse ARP or does it just overwrite the dynamic mapping?Thanks

jaighobahi by Level 1
  • 12179 Views
  • 11 replies
  • 0 Helpful votes

Resolved! Route-object

Dear Expert,I would like to ask you regarding creating a route object in RIPE NCC.If i am a transit ISP, i am receiving a prefix from my end user ans advertise it to internet and the customer will be the originator for this prefix.In this case, do i ...

Dear Expert,I would like to ask you regarding creating a route object in RIPE NCC.If i am a transit ISP, i am receiving a prefix from my end user ans advertise it to internet and the customer will be the originator for this prefix.In this case, do i ...

Dear team,Belwo is the specifications of PRP-2. What is the diff b/n Operating and storage temperature and humidity.DescriptionSpecificationTemperature• Operating: 32 to 104°F (0 to 40°C)• Storage: -4 to 149°F (-20 to 65°C)Humidity• Operating (noncon...

Unanswered Topics